Half-Life-Week-

tarekelbehiry468-commits·Half-Life-Week-·PCB/Starbie.kicad_pcb

Half-Life-Week- PCB layout, top view — open source ESP32 board by tarekelbehiry468-commits

About the Half-Life-Week- PCB

Half-Life-Week- is an open source ESP32 PCB design by tarekelbehiry468-commits, published on GitHub under the MIT license. It is a 2-layer board measuring 96.6 × 82.8 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the sensors, keyboards and displays & leds designs in this gallery.

From the project

Starbie is a tiny motion-controlled digital pet created as the Week 1 beginner hardware project for Hack Club Half Life. It sits on a desk, shows an animated pet on a 0.96-inch OLED, and reacts when the board is tilted, moved, or shaken.

Starbie is a tiny motion-controlled digital pet created as the Week 1 beginner hardware project for Hack Club Half Life. It sits on a desk, shows an animated pet on a 0.96-inch OLED, and reacts when the board is tilted, moved, or shaken.

A Seeed Studio XIAO ESP32-C3 drives the display, reads an MPU6050 motion sensor, and optionally reads temperature and humidity from a DHT11. The firmware stores joy, energy, and fullness in the ESP32's non-volatile preferences. Two buttons and a tilt-controlled radial menu provide interaction.

Half-Life-Week-, from the project README
From the project README

Main components on the Half-Life-Week-

Half-Life-Week- bill of materials (BOM)

7 components, 6 distinct parts.

QtyPartRefs
1
DHT11
U1
1
XIAO-ESP32-C3-SMD
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
10k
R1

Half-Life-Week- design files

The KiCad project lives in the tarekelbehiry468-commits/Half-Life-Week- repository on GitHub; these links point at the commit this page was built from.

Half-Life-Week-: common questions

What microcontroller does the Half-Life-Week- use?

The Half-Life-Week- is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Half-Life-Week- PCB?

The Half-Life-Week- measures 96.6 × 82.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Half-Life-Week-?

7 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Half-Life-Week- design files?

From the tarekelbehiry468-commits/Half-Life-Week- repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Half-Life-Week- design in my own project?

Yes, under the terms of its MIT license, which tarekelbehiry468-commits chose for the repository.

Can I test firmware for the Half-Life-Week- without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards