Hacktolife

tejuas98·hacktolife·PCB/Starbie.kicad_pcb

Hacktolife PCB layout, top view — open source ESP32 board by tejuas98

About the Hacktolife PCB

Hacktolife is an open source ESP32 PCB design by tejuas98, published on GitHub under the MIT license. It is a 2-layer board measuring 96.6 × 82.8 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the iot & wireless, sensors and displays & leds designs in this gallery.

From the project

Starbie is a desktop digital pet with motion interactivity. Instead of only pressing buttons, you physically tilt and shake the board to play with your pet, navigate the 4-way radial menu, and monitor environmental conditions!

Starbie is a desktop digital pet with motion interactivity. Instead of only pressing buttons, you physically tilt and shake the board to play with your pet, navigate the 4-way radial menu, and monitor environmental conditions!

- Button 1 (Menu): Press to bring up the 4-way radial menu. Tilt the board to guide the cursor into a sector: - TOP: NAP (Starbie sleeps and emits Zs) - RIGHT: PLAY (Starbie runs fast laps) - BOTTOM: FEED (Fullness restore & happy jump) - LEFT: PET (Emits floating heart icons) - Press Button 1 again to confirm the action! - Button 2 (Stats Overlay): Press to toggle the…

Main components on the Hacktolife

Hacktolife bill of materials (BOM)

7 components, 6 distinct parts.

QtyPartRefs
1
DHT11
U1
1
XIAO-ESP32-C3-SMD
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
10k
R1

Hacktolife design files

The KiCad project lives in the tejuas98/hacktolife repository on GitHub; these links point at the commit this page was built from.

Hacktolife: common questions

What microcontroller does the Hacktolife use?

The Hacktolife is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Hacktolife PCB?

The Hacktolife measures 96.6 × 82.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Hacktolife?

7 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Hacktolife design files?

From the tejuas98/hacktolife repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Hacktolife design in my own project?

Yes, under the terms of its MIT license, which tejuas98 chose for the repository.

Can I test firmware for the Hacktolife without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards