Prot3

Tellurnoid·newLine·KiCad/prot3/prot3.kicad_pcb

Prot3 PCB layout, top view — open source RP2040/RP2350 board by Tellurnoid

About the Prot3 PCB

Prot3 is an open source RP2040/RP2350 PCB design by Tellurnoid, published on GitHub. It is a 2-layer board measuring 140 × 140 mm, with 197 components from 14 distinct parts.

Its main chip is the RP2040_zero_kimoi3, from the RP2040/RP2350 family. Other key parts include the LM339 and LM393. By type, the board carries 33 diodes, 32 transistors, 18 capacitors, 8 ICs, 3 connectors and 1 speaker.

Main components on the Prot3

Prot3 bill of materials (BOM)

197 components, 14 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
LM339
U1
7
LM393
LM339
U2, U3, U4, U5, U6, U7, U8
32
Q_Photo_NPN
Q1, Q2, Q3, Q4, Q5, Q6, Q7, Q8 +24
1
CONN_01X04_SOCKET
Conn_01x02_Socket
J1
1
CONN_01X02_SOCKET
LED_SW
J2
1
Conn_01x04_Socket
J3
98
R
B1, B2, Rc1, Rc2, Rc3, Rc4, Rc5, Rc6 +90
1
Speaker_Crystal
LS1
2
~
RP2040_Zero1, RP2040_Zero2
1
R_Potentiometer_Trim
RV1
32
LED
D1, D2, D3, D4, D5, D6, D7, D8 +24
1
D_Schottky
D33
18
C
C1, C2, C3, C4, C5, C6, C7, C8 +10
1
R
R1

Prot3 design files

The KiCad project lives in the Tellurnoid/newLine repository on GitHub; these links point at the commit this page was built from.

Prot3: common questions

What microcontroller does the Prot3 use?

The Prot3 is built around the RP2040_zero_kimoi3, from the RP2040/RP2350 family.

How big is the Prot3 PCB?

The Prot3 measures 140 × 140 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Prot3?

197 components, from 14 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Prot3 design files?

From the Tellurnoid/newLine repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Prot3 design in my own project?

The repository has no license, so all rights stay with Tellurnoid. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Prot3 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

More boards in newLine

Similar boards