Kicad pill dispenser

tikhonp·kicad-pill-dispenser

Kicad pill dispenser PCB layout, top view — open source ESP32 board by tikhonp

About the Kicad pill dispenser PCB

Kicad pill dispenser is an open source ESP32 PCB design by tikhonp, published on GitHub. It is a 2-layer board measuring 50 × 50 mm, with 35 components from 31 distinct parts.

Its main chip is the ESP32-C3-Zero, from the ESP32 family. Other key parts include the MT3608, TP4056-42-ESOP8, DW01A and IRLML2502. By type, the board carries 12 resistors, 5 ICs, 4 diodes, 4 capacitors, 3 switches and 2 transistors.

From the project

Schematic for Telepat Pill Dispenser powered by esp32c3

Main components on the Kicad pill dispenser

Kicad pill dispenser bill of materials (BOM)

35 components, 31 distinct parts.

QtyPartRefs
1
MT3608
U1
1
ESP32-C3-Zero
U2
1
TP4056-42-ESOP8
U3
1
DW01A
U4
1
IRLML2502
U5
1
AO3401A
Q1
1
FS8205A
Q2
1
USB-C
J1
1
WS2812B
J3
1
Battery_Cell
BT1
1
Buzzer
BZ1
1
Reset Button
S1
1
Button
S2
1
Battery Switch
SW1
1
SS34
D1
1
MBR0520
D2
1
GREEN
D3
1
RED
D4
1
22uH
L1
2
22uF
C1, C2
Show 11 more
QtyPartRefs
1
10uF
C3
1
0.1uF
C4
1
75К
R1
2
5.1k
R2, R3
1
100k
R4
1
10K
R5
3
1K
R6, R9, R12
1
100
R7
1
30K
R8
1
3.9K
R10
1
75K
R11

Kicad pill dispenser design files

The KiCad project lives in the tikhonp/kicad-pill-dispenser repository on GitHub; these links point at the commit this page was built from.

Kicad pill dispenser: common questions

What microcontroller does the Kicad pill dispenser use?

The Kicad pill dispenser is built around the ESP32-C3-Zero, from the ESP32 family.

How big is the Kicad pill dispenser PCB?

The Kicad pill dispenser measures 50 × 50 mm, has 2 copper layers and is 1.59 mm thick.

How many components are on the Kicad pill dispenser?

35 components, from 31 distinct parts. The full bill of materials is listed on this page.

Where can I download the Kicad pill dispenser design files?

From the tikhonp/kicad-pill-dispenser repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Kicad pill dispenser design in my own project?

The repository has no license, so all rights stay with tikhonp. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Kicad pill dispenser without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards