Base Starbie

Tomer-Sagie·Starbie·hardware/prodhardware/Base Starbie.kicad_pcb

Base Starbie PCB layout, top view — open source ESP32 board by Tomer-Sagie

About the Base Starbie PCB

Base Starbie is an open source ESP32 PCB design by Tomer-Sagie, published on GitHub. It is a 2-layer board measuring 98 × 93.5 mm, with 12 components from 9 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches, 2 diodes, 2 capacitors and 2 resistors.

From the project

Its basicaly a tamagotchi that you can intertact with through haptics, sound, lights, and a screem as well as a motion sensor which is cool.

Its basicaly a tamagotchi that you can intertact with through haptics, sound, lights, and a screem as well as a motion sensor which is cool.

Not much else to say lol, check out my half life project page for the full timeline with timelapses and journal entries n stuff.

Base Starbie, from the project README
From the project README

Main components on the Base Starbie

Base Starbie bill of materials (BOM)

12 components, 9 distinct parts.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
DHT11
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
2
WS2812B
D1, D2
2
100nF
C1, C2
1
10k
R1
1
330Ω
R3

Base Starbie design files

The KiCad project lives in the Tomer-Sagie/Starbie repository on GitHub; these links point at the commit this page was built from.

Base Starbie: common questions

What microcontroller does the Base Starbie use?

The Base Starbie is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Base Starbie PCB?

The Base Starbie measures 98 × 93.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Base Starbie?

12 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Base Starbie design files?

From the Tomer-Sagie/Starbie repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Base Starbie design in my own project?

The repository has no license, so all rights stay with Tomer-Sagie. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Base Starbie without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in Starbie

Similar boards