TrailCurrentPlateau

trailcurrentoss·TrailCurrentPlateau·EDA/TrailCurrentPlateau/TrailCurrentPlateau.kicad_pcb

TrailCurrentPlateau PCB layout, top view — open source ESP32 board by trailcurrentoss

About the TrailCurrentPlateau PCB

TrailCurrentPlateau is an open source ESP32 PCB design by trailcurrentoss, published on GitHub under the MIT license. It is a 2-layer board measuring 68.1 × 57.9 mm, with 16 components from 9 distinct parts.

Its main chip is the ESP32-S3-Zero, from the ESP32 family. Other key parts include the SN65HVD230DR, BNO055 and Mini560. By type, the board carries 6 resistors, 5 capacitors, 4 ICs and 1 connector.

It belongs with the iot & wireless and sensors designs in this gallery.

From the project

Vehicle and trailer leveling control module with CAN bus communication

Vehicle leveling module that monitors trailer tilt angles and computes per-corner height adjustments via a CAN bus interface with OTA firmware update capability. Part of the TrailCurrent open-source vehicle platform.

- Microcontroller: ESP32-S3 (Waveshare ESP32-S3-RS485-CAN) - IMU: DFRobot SEN0253 Gravity 10-DOF AHRS (Bosch BNO055) - Function: Vehicle leveling with CAN bus communication - Key Features: - BNO055 IMU for pitch/roll measurement with auto-calibration - Per-corner height adjustment calculation from vehicle dimensions - Three mounting orientations (floor, left wall, right wall)…

TrailCurrentPlateau, from the project README
From the project README

Main components on the TrailCurrentPlateau

TrailCurrentPlateau bill of materials (BOM)

16 components, 9 distinct parts.

QtyPartRefs
1
SN65HVD230DR
IC1
1
BNO055
U1
1
Mini560
U5
1
ESP32-S3-Zero
U6
1
S4B-XH-SM4-TB
J2
2
1uF
C1, C4
2
100nF
C2, C3
1
10uF
C6
6
10k
R3, R4, R5, R6, R7, R8

TrailCurrentPlateau design files

The KiCad project lives in the trailcurrentoss/TrailCurrentPlateau repository on GitHub; these links point at the commit this page was built from.

TrailCurrentPlateau: common questions

What microcontroller does the TrailCurrentPlateau use?

The TrailCurrentPlateau is built around the ESP32-S3-Zero, from the ESP32 family.

How big is the TrailCurrentPlateau PCB?

The TrailCurrentPlateau measures 68.1 × 57.9 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the TrailCurrentPlateau?

16 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the TrailCurrentPlateau design files?

From the trailcurrentoss/TrailCurrentPlateau repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the TrailCurrentPlateau design in my own project?

Yes, under the terms of its MIT license, which trailcurrentoss chose for the repository.

Can I test firmware for the TrailCurrentPlateau without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards