Starboy proj

Uncle-Noon·Starboy-proj·Starboy/Starbie-proj.kicad_pcb

Starboy proj PCB layout, top view — open source ESP32 board by Uncle-Noon

About the Starboy proj PCB

Starboy proj is an open source ESP32 PCB design by Uncle-Noon, published on GitHub. It is a 2-layer board measuring 208.1 × 148.6 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the sensors and displays & leds designs in this gallery.

From the project

Making a starbie tamotogachi for Half-Life program

Starboy is a tiny motion-controlled digital pet: basically a desktop Tamagotchi with minimal gameplay buttons. Instead of pressing controls, you interact with it by physically moving the board.

Starboy is designed to sit on your desk, show its personality on a small display, and react to how you handle it. Tilting, moving, and otherwise checking in on your pet are meant to be part of the experience.

Starboy proj, from the project README
From the project README

Main components on the Starboy proj

Starboy proj bill of materials (BOM)

7 components, 6 distinct parts.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
DHT11
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
10k
R1

Starboy proj design files

The KiCad project lives in the Uncle-Noon/Starboy-proj repository on GitHub; these links point at the commit this page was built from.

Starboy proj: common questions

What microcontroller does the Starboy proj use?

The Starboy proj is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Starboy proj PCB?

The Starboy proj measures 208.1 × 148.6 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Starboy proj?

7 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Starboy proj design files?

From the Uncle-Noon/Starboy-proj repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Starboy proj design in my own project?

The repository has no license, so all rights stay with Uncle-Noon. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Starboy proj without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards