On AIR controller board

ViktorStiskala·ON-AIR·Controller/Controller.kicad_pcb

On AIR controller board layout, top view — open source ESP32 board by ViktorStiskala

About the On AIR controller board

On AIR controller board is an open source ESP32 PCB design by ViktorStiskala, published on GitHub. It is a 2-layer board measuring 64 × 52 mm, with 38 components from 23 distinct parts.

Its main chip is the ESP32-S2-WROVER, from the ESP32 family. Other key parts include the STUSB4500QTR, LMZM23600V3 and TMP117. By type, the board carries 15 resistors, 7 capacitors, 4 ICs, 4 diodes, 3 connectors and 3 switches.

From the project

On AIR LED board + controller

Main components on the On AIR controller board

On AIR controller board bill of materials (BOM)

38 components, 23 distinct parts.

QtyPartRefs
1
ESP32-S2-WROVER
U101
1
STUSB4500QTR
U301
1
LMZM23600V3
U401
1
TMP117
U402
1
BSC0503NSI
Q101
1
USB_C_Receptacle
J101
1
Screw_Terminal_01x02
J102
1
ESProg_Mating_Header
P101
1
Polyfuse
F101
1
RESET
SW101
1
SW_EXT
SW102
1
SETUP
SW103
1
ERROR
D101
2
ESDA25P35
D301, D303
1
ESDA25W
D302
4
1uF
C101, C301, C302, C303
1
0.1uF
C102
1
10uF
C401
1
33uF
C402
1
60R
R101
Show 3 more
QtyPartRefs
11
10K
R102, R103, R104, R105, R106, R107, R108, R109 +3
1
100K
R201
2
1K
R301, R302

On AIR controller board design files

The KiCad project lives in the ViktorStiskala/ON-AIR repository on GitHub; these links point at the commit this page was built from.

On AIR controller board: common questions

What microcontroller does the On AIR controller board use?

The On AIR controller board is built around the ESP32-S2-WROVER, from the ESP32 family.

How big is the On AIR controller board?

The On AIR controller board measures 64 × 52 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the On AIR controller board?

38 components, from 23 distinct parts. The full bill of materials is listed on this page.

Where can I download the On AIR controller board design files?

From the ViktorStiskala/ON-AIR repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the On AIR controller board design in my own project?

The repository has no license, so all rights stay with ViktorStiskala. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the On AIR controller board without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in ON-AIR

Similar boards