Vince-Ha3k

vincent2013lam-commits·Vince-Ha3k

Vince-Ha3k PCB layout, top view — open source ESP32 board by vincent2013lam-commits

About the Vince-Ha3k PCB

Vince-Ha3k is an open source ESP32 PCB design by vincent2013lam-commits, published on GitHub. It is a 2-layer board measuring 105 × 80 mm, with 7 components from 6 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. Other key parts include the DHT11. By type, the board carries 2 ICs, 2 connectors, 2 switches and 1 resistor.

It belongs with the keyboards, displays & leds and sensors designs in this gallery.

From the project

Starbie is an interactive electronic pet. It features a microcontroller, buttons, an Arduino code, and a custom design. The project consists with a Kicad schematic design, hosting all of the components, and a pcb design, where we construct and place all of the components. The cod

Starbie is an interactive electronic pet. It features a microcontroller, buttons, an Arduino code, and a custom design. The project consists with a Kicad schematic design, hosting all of the components, and a pcb design, where we construct and place all of the components. The code is in Aduino and in C++, featuring all of the starbie's responses and overall behavior.

Vince-Ha3k, from the project README
From the project README

Main components on the Vince-Ha3k

Vince-Ha3k bill of materials (BOM)

7 components, 6 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
DHT11
U2
1
Conn_01x04_Pin
J1
1
Conn_01x08_Pin
J2
2
SW_Push
SW1, SW2
1
10k
R1

Vince-Ha3k design files

The KiCad project lives in the vincent2013lam-commits/Vince-Ha3k repository on GitHub; these links point at the commit this page was built from.

Vince-Ha3k: common questions

What microcontroller does the Vince-Ha3k use?

The Vince-Ha3k is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the Vince-Ha3k PCB?

The Vince-Ha3k measures 105 × 80 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Vince-Ha3k?

7 components, from 6 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Vince-Ha3k design files?

From the vincent2013lam-commits/Vince-Ha3k repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Vince-Ha3k design in my own project?

The repository has no license, so all rights stay with vincent2013lam-commits. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Vince-Ha3k without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards