Solar Power Monitoring System

ysaip07·KiCAD_Project·Solar Monitoring System/Solar_Power_Monitoring.kicad_pcb

Solar Power Monitoring System PCB layout, top view — open source AVR/Arduino board by ysaip07

About the Solar Power Monitoring System PCB

Solar Power Monitoring System is an open source AVR/Arduino PCB design by ysaip07, published on GitHub. It is a 2-layer board measuring 125.7 × 103 mm, with 14 components from 11 distinct parts.

Its main chip is the Arduino_UNO_R3, from the AVR/Arduino family. Other key parts include the ACS712ELCTR-05B-T. By type, the board carries 3 resistors, 1 IC, 1 module, 1 connector, 1 diode and 1 capacitor.

It belongs with the displays & leds, power & battery and iot & wireless designs in this gallery.

From the project

Personal PCB design projects using KiCad, reflecting a strong foundation in electronics design, component footprints, and PCB fabrication workflows.

A Solar Panel Monitoring System PCB designed using KiCad. This board enables real-time measurement and logging of solar panel voltage, current, and power output — providing actionable data for solar energy performance analysis and optimization. System Description The Solar Monitoring System uses voltage dividers and current sensing ICs to measure panel output parameters. A microcontroller reads ADC values, computes power, and outputs data to a display or wireless interface for remote monitoring.

Main components on the Solar Power Monitoring System

Solar Power Monitoring System bill of materials (BOM)

14 components, 11 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ACS712ELCTR-05B-T
IC1
1
Arduino_UNO_R3
A1
1
Solar Input
J1
1
HY1602E
DS1
1
potentiometer_RM065
RV1
4
1.25mm
TP_GND1, TP_IN1, TP_OUT1, TP_VDIV1
1
LED
D1
1
0.1UF
0.1uF
C1
1
10K
10k
R1
1
100K
2.2k
R2
1
220ohms
R3

Solar Power Monitoring System design files

The KiCad project lives in the ysaip07/KiCAD_Project repository on GitHub; these links point at the commit this page was built from.

Solar Power Monitoring System: common questions

What microcontroller does the Solar Power Monitoring System use?

The Solar Power Monitoring System is built around the Arduino_UNO_R3, from the AVR/Arduino family.

How big is the Solar Power Monitoring System PCB?

The Solar Power Monitoring System measures 125.7 × 103 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Solar Power Monitoring System?

14 components, from 11 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Solar Power Monitoring System design files?

From the ysaip07/KiCAD_Project repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Solar Power Monitoring System design in my own project?

The repository has no license, so all rights stay with ysaip07. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Solar Power Monitoring System without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in KiCAD_Project

Similar boards