F722-2020-fc
ABHISHEK22415·f722-2020-fc·hardware/kicad/f722-2020-fc.kicad_sch
About the F722-2020-fc PCB
F722-2020-fc is an open source STM32 PCB design by ABHISHEK22415, published on GitHub. It is a board, with 148 components from 82 distinct parts.
Its main chip is the STM32F722RET6, from the STM32 family. Other key parts include the MPU-6000, AT7456E, W25Q128JVPIQ, BMP280 and MAX17572. By type, the board carries 48 capacitors, 35 resistors, 33 test points, 10 ICs, 7 inductors and 5 diodes.
It belongs with the robotics & motion and sensors designs in this gallery.
From the project
20x20 FPV flight controller: STM32F722 + MPU6000, 6 ARTs, 8 motors. Design spec, noise review, BOM, Betalight config and 3D viewer.
- f722-2020-fc.kicadsch: full schematic, 152 parts, 106 nets, built from KiCad's official libraries plus two custom symbols (fc.kicadsym: AT7456E, TPS7A2033). - f722-2020-fc-schematic.pdf: printable copy. - Altium: File → Import Wizard → KiCad, select the .kicadpro`. - Verified: KiCad's exported netlist matches the intended design on all 422 pin connections; no single-pin nets.
Main components on the F722-2020-fc
F722-2020-fc bill of materials (BOM)
148 components, 82 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | STM32F722RET6 | LQFP-64_10x10mm_P0.5mm | U1 |
| 1 | MPU-6000 | InvenSense_QFN-24_4x4mm_P0.5mm | U2 |
| 1 | AT7456E | TSSOP-28-1EP_4.4x9.7mm_P0.65mm | U3 |
| 1 | W25Q128JVPIQ | WSON-8-1EP_6x5mm_P1.27mm_EP3.4x4mm | U4 |
| 1 | BMP280 | Bosch_LGA-8_2x2.5mm_P0.65mm_ClockwisePinNumbering | U5 |
| 2 | MAX17572 | DFN-12-1EP_3x3mm_P0.5mm_EP2.05x2.86mm | U6, U7 |
| 1 | TLV75533PDBV | SOT-23-5 | U8 |
| 1 | TPS7A2033PDBV | SOT-23-5 | U9 |
| 1 | USBLC6-2SC6 | SOT-23-6 | U10 |
| 1 | AO3400A | SOT-23 | Q1 |
| 1 | 8MHz | Crystal_SMD_3225-4Pin_3.2x2.5mm | Y1 |
| 1 | 27MHz | Crystal_SMD_3225-4Pin_3.2x2.5mm | Y2 |
| 1 | ESC | JST_SH_BM08B-SRSS-TB_1x08-1MP_P1.00mm_Vertical | J1 |
| 1 | HD VTX | JST_SH_BM06B-SRSS-TB_1x06-1MP_P1.00mm_Vertical | J2 |
| 1 | GPS | JST_SH_BM06B-SRSS-TB_1x06-1MP_P1.00mm_Vertical | J3 |
| 1 | USB-C | USB_C_Receptacle_HRO_TYPE-C-31-M-12 | J4 |
| 1 | 1A hold | Fuse_1206_3216Metric | F1 |
| 1 | VTX 10V/5V | SolderJumper-3_P1.3mm_Open_RoundedPad1.0x1.5mm | JP1 |
| 1 | BOOT | SW_SPST_B3U-1000P | SW1 |
| 3 | 5V | TestPoint_Pad_1.5x1.5mm | TP1, TP5, TP9 |
Show 62 more
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 5 | GND | TestPoint_Pad_1.5x1.5mm | TP2, TP6, TP10, TP18, TP23 |
| 1 | T2 | TestPoint_Pad_1.5x1.5mm | TP3 |
| 1 | R2 | TestPoint_Pad_1.5x1.5mm | TP4 |
| 1 | T6 | TestPoint_Pad_1.5x1.5mm | TP7 |
| 1 | R6 | TestPoint_Pad_1.5x1.5mm | TP8 |
| 1 | T5 | TestPoint_Pad_1.5x1.5mm | TP11 |
| 1 | R5 | TestPoint_Pad_1.5x1.5mm | TP12 |
| 1 | RSSI | TestPoint_Pad_1.5x1.5mm | TP13 |
| 1 | LED | TestPoint_Pad_1.5x1.5mm | TP14 |
| 1 | BZ- | TestPoint_Pad_1.5x1.5mm | TP15 |
| 1 | BZ+ | TestPoint_Pad_1.5x1.5mm | TP16 |
| 1 | CAM | TestPoint_Pad_1.5x1.5mm | TP17 |
| 1 | VIN | TestPoint_Pad_1.5x1.5mm | TP19 |
| 1 | CC | TestPoint_Pad_1.5x1.5mm | TP20 |
| 1 | VOUT | TestPoint_Pad_1.5x1.5mm | TP21 |
| 1 | VTX | TestPoint_Pad_1.5x1.5mm | TP22 |
| 1 | TX4 | TestPoint_Pad_1.5x1.5mm | TP24 |
| 1 | M5 | TestPoint_Pad_1.5x1.5mm | TP25 |
| 1 | M6 | TestPoint_Pad_1.5x1.5mm | TP26 |
| 1 | M7 | TestPoint_Pad_1.5x1.5mm | TP27 |
| 1 | M8 | TestPoint_Pad_1.5x1.5mm | TP28 |
| 1 | SDA | TestPoint_Pad_1.5x1.5mm | TP29 |
| 1 | SCL | TestPoint_Pad_1.5x1.5mm | TP30 |
| 1 | DIO | TestPoint_Pad_1.5x1.5mm | TP31 |
| 1 | CLK | TestPoint_Pad_1.5x1.5mm | TP32 |
| 1 | NRST | TestPoint_Pad_1.5x1.5mm | TP33 |
| 1 | SMF33A | D_SOD-123F | D1 |
| 1 | B5819W | D_SOD-123 | D2 |
| 1 | BAT54 | D_SOD-323 | D3 |
| 1 | Blue | LED_0603_1608Metric | D4 |
| 1 | Green | LED_0603_1608Metric | D5 |
| 3 | 600R@100MHz | L_0201_0603Metric | FB1, FB2, FB3 |
| 2 | 10uH | L_Taiyo-Yuden_MD-3030 | L1, L2 |
| 2 | 2.2uH | L_0805_2012Metric | L3, L4 |
| 21 | 100nF | C_0201_0603Metric | C1, C2, C3, C4, C8, C9, C12, C13 +13 |
| 1 | 4.7uF | C_0603_1608Metric | C5 |
| 1 | 2.2uF | C_0603_1608Metric | C6 |
| 4 | 1uF | C_0402_1005Metric | C7, C16, C45, C46 |
| 2 | 10pF | C_0201_0603Metric | C10, C11 |
| 1 | 2.2nF 50V | C_0402_1005Metric | C14 |
| 2 | 10uF | C_0603_1608Metric | C15, C19 |
| 2 | 22pF | C_0201_0603Metric | C24, C25 |
| 2 | 4.7uF 50V | C_1206_3216Metric | C29, C37 |
| 2 | 100nF 50V | C_0402_1005Metric | C30, C38 |
| 2 | 4.7uF 10V | C_0603_1608Metric | C31, C39 |
| 2 | 5.6nF | C_0201_0603Metric | C33, C41 |
| 6 | 22uF 25V | C_0805_2012Metric | C35, C36, C43, C44, C47, C48 |
| 6 | 10k | R_0201_0603Metric | R1, R2, R3, R4, R7, R25 |
| 2 | 2.2k | R_0201_0603Metric | R5, R6 |
| 1 | 10k | R_0402_1005Metric | R8 |
| 4 | 1k | R_0201_0603Metric | R9, R18, R22, R23 |
| 2 | 19.1k | R_0201_0603Metric | R10, R14 |
| 2 | 4.7R | R_0201_0603Metric | R11, R15 |
| 1 | 178k | R_0201_0603Metric | R12 |
| 1 | 39k | R_0201_0603Metric | R13 |
| 1 | 200k | R_0201_0603Metric | R16 |
| 1 | 19.6k | R_0201_0603Metric | R17 |
| 1 | 100k | R_0201_0603Metric | R19 |
| 2 | 5.1k | R_0201_0603Metric | R20, R21 |
| 1 | 100R | R_0201_0603Metric | R24 |
| 2 | 330R | R_0201_0603Metric | R26, R27 |
| 8 | 47R | R_0201_0603Metric | R28, R29, R30, R31, R32, R33, R34, R35 |
F722-2020-fc design files
The KiCad project lives in the ABHISHEK22415/f722-2020-fc repository on GitHub; these links point at the commit this page was built from.
F722-2020-fc: common questions
What microcontroller does the F722-2020-fc use?
The F722-2020-fc is built around the STM32F722RET6, from the STM32 family.
How many components are on the F722-2020-fc?
148 components, from 82 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the F722-2020-fc design files?
From the ABHISHEK22415/f722-2020-fc repository on GitHub, which has the schematic and the BOM; the links under Design files point to each one.
Can I use the F722-2020-fc design in my own project?
The repository has no license, so all rights stay with ABHISHEK22415. Use it as a reference, and ask the author before reusing the design.
Can I test firmware for the F722-2020-fc without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.
Similar boards
STM32
LumenPnP Motherboard
opulo-inc
149 × 95 mm296 parts4LCC-BY-SA-4.03.7kSTM32
Type g
google
169 × 30 mm24 parts2LApache-2.02.9kSTM32
Base
google
52.3 × 52.3 mm36 parts2LApache-2.02.9kSTM32
Main panel
google
234 × 84 mm26 parts4LApache-2.02.9kSTM32
Type a
google
150 × 30 mm14 parts2LApache-2.02.9kSTM32
Type c
google
188 × 30 mm17 parts2LApache-2.02.9k