Finger FSR V1 length

selina101·CreateLabWork·Hands/FSRs/PCBs/Finger_FSR_V1_length/Finger_FSR_V1_length.kicad_pcb

Finger FSR V1 length PCB layout, top view — open source board by selina101

About the Finger FSR V1 length PCB

Finger FSR V1 length is an open source PCB design by selina101, published on GitHub. It is a 2-layer board measuring 55.3 × 82.3 mm, with 24 components from 4 distinct parts.

Other key parts include the pad.

From the project

Repo with projects done during my thesis and the valorisation.

There are three PCBs for the finger FSRs: - The FPCB that has the electrodes in its height. It has the back side in contact with the finger, and the electrodes in contact with the velostat. - The FPCB that has the electrodes in its width, and the circular electrodes on the front. The rectangular electrodes are put in contact with the velostat, and the circular electrodes allow for connections to a hydrogel if desired - A main PCB that helps connect all these electrodes to a Teensy microcontroller.

Finger FSR V1 length, from the project README
From the project README

Main components on the Finger FSR V1 length

Finger FSR V1 length bill of materials (BOM)

24 components, 4 distinct parts — part numbers from the project's BOM.

QtyPartRefs
6
pad
U1, U2, U3, U4, U5, U6
6
pad
U7, U8, U9, U10, U11, U12
6
Finger_FSR_V1_Length
E1, E2, E3, E4, E5, E6
6
~
E7, E8, E9, E10, E11, E12

Finger FSR V1 length design files

The KiCad project lives in the selina101/CreateLabWork repository on GitHub; these links point at the commit this page was built from.

Finger FSR V1 length: common questions

How big is the Finger FSR V1 length PCB?

The Finger FSR V1 length measures 55.3 × 82.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Finger FSR V1 length?

24 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Finger FSR V1 length design files?

From the selina101/CreateLabWork repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Finger FSR V1 length design in my own project?

The repository has no license, so all rights stay with selina101. Use it as a reference, and ask the author before reusing the design.

More boards in CreateLabWork