IMU Main

selina101·CreateLabWork·IMU/IMU_V3/IMU_MainPCB/IMU_MainPCB.kicad_pcb

IMU Main PCB layout, top view — open source NXP board by selina101

About the IMU Main PCB

IMU Main is an open source NXP PCB design by selina101, published on GitHub. It is a 2-layer board measuring 52.8 × 33 mm, with 9 components from 4 distinct parts.

Its main chip is the TEENSY_4.0, from the NXP family. By type, the board carries 4 connectors, 4 resistors and 1 IC.

It belongs with the sensors designs in this gallery.

From the project

Repo with projects done during my thesis and the valorisation.

For the PCBs, you will find all the KiCAD files, as well as the gerber files to be able to order PCBs. The file 'PCB library' contains the footprint, the symbols and the 3D models of all the components used for all of the PCBs.

All the components were bought separately and soldered by hand.

For all the Hall sensor PCBs, all the components were bought separately and soldered by hand.

IMU Main, from the project README
From the project README

Main components on the IMU Main

IMU Main bill of materials (BOM)

9 components, 4 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
TEENSY_4.0
Teensy_4.0
U1
2
4_PIN_HEADER
4_pin_header
J1, J2
2
~
J3, J4
4
R
R1, R2, R3, R4

IMU Main design files

The KiCad project lives in the selina101/CreateLabWork repository on GitHub; these links point at the commit this page was built from.

IMU Main: common questions

What microcontroller does the IMU Main use?

The IMU Main is built around the TEENSY_4.0, from the NXP family.

How big is the IMU Main PCB?

The IMU Main measures 52.8 × 33 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the IMU Main?

9 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the IMU Main design files?

From the selina101/CreateLabWork repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the IMU Main design in my own project?

The repository has no license, so all rights stay with selina101. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the IMU Main without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug NXP firmware against it before you order a PCB.

More boards in CreateLabWork

Similar boards