Smoke

speck0413·ai-native-eda·examples/smoke/kicad/smoke.kicad_pcb

Smoke PCB layout, top view — open source ESP32 board by speck0413

About the Smoke PCB

Smoke is an open source ESP32 PCB design by speck0413, published on GitHub under the MIT license. It is a 2-layer board measuring 22 × 16 mm, with 9 components from 7 distinct parts.

Its main chip is the ESP32-C3-WROOM-02, from the ESP32 family. By type, the board carries 3 capacitors, 3 resistors, 1 IC, 1 connector and 1 diode.

From the project

Intent-level PCB layout for AI agents

This small routed regression exercises USB-C sink pull-downs, relational placement, decoupling, explicit net classes, a two-layer ground plane/pour, linked schematic generation and manufacturing export. It is a prototype example; no physical board or supplier-placement approval is recorded.

The source pins placement seed 2. Open kicad/smoke.kicadpro in KiCad 10 to inspect the committed linked PCB and schematic, or open the project in the chosen output directory. Edit board.ts and rebuild; generated KiCad files are inspectable outputs. Toolchain: this repository (../../bin/aieda relative to…

Main components on the Smoke

Smoke bill of materials (BOM)

9 components, 7 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ESP32-C3-WROOM-02
AP2112K-3.3
U1
1
USB4105-GF-A
J1
1
B5819W
green
D1
2
10u
C1, C2
1
100n
C3
2
5.1k
R1, R2
1
330
R3

Smoke design files

The KiCad project lives in the speck0413/ai-native-eda repository on GitHub; these links point at the commit this page was built from.

Smoke: common questions

What microcontroller does the Smoke use?

The Smoke is built around the ESP32-C3-WROOM-02, from the ESP32 family.

How big is the Smoke PCB?

The Smoke measures 22 × 16 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Smoke?

9 components, from 7 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Smoke design files?

From the speck0413/ai-native-eda repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Smoke design in my own project?

Yes, under the terms of its MIT license, which speck0413 chose for the repository.

Can I test firmware for the Smoke without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in ai-native-eda

Similar boards