High side or ing power selection

Tim4769·Microver·hardware/final/High_Side_OR_ing_manufacturing_rev_a/Kicad_High Side OR ing/High Side OR ing.kicad_pcb

High side or ing power selection PCB layout, top view — open source NXP board by Tim4769

About the High side or ing power selection PCB

High side or ing power selection is an open source NXP PCB design by Tim4769, published on GitHub under the Custom license license. It is a 4-layer board measuring 36 × 31 mm, with 13 components from 9 distinct parts.

Its main chip is the C2653552, from the NXP family. By type, the board carries 5 connectors, 2 ICs, 2 transistors, 2 capacitors and 2 resistors.

It belongs with the power & battery designs in this gallery.

From the project

Swiss Rover Challenge rover project with final electronics, mechanical handoff files, PCB validation firmware, and shared project assets.

Project: LM5050 Redundant Supply Board Owner / Contact: Tim Wang - timwang007@outlook.com Revision: Rev A Date: 2026-02-11

The goal is seamless source switchover while preventing backfeed into the inactive source.

High side or ing power selection, from the project README
From the project README

Main components on the High side or ing power selection

C2653552

High side or ing power selection bill of materials (BOM)

13 components, 9 distinct parts — part numbers from the project's BOM.

QtyPartRefs
2
C2653552
LM5050MKX-1/NOPB
U1, U2
2
TPH2R608NH_L1Q kicad
Q1, Q2
1
C2937625
Conn_01x02_Pin
J1
2
C492401
Conn_01x02_Pin
J2, J3
2
Conn_01x02_Pin
J4, J6
1
C106697
100nF
C1
1
C19666
100nF
C2
1
C23138
100Ω
R1
1
C22765
100Ω
R2

High side or ing power selection design files

The KiCad project lives in the Tim4769/Microver repository on GitHub; these links point at the commit this page was built from.

High side or ing power selection: common questions

What microcontroller does the High side or ing power selection use?

The High side or ing power selection is built around the C2653552, from the NXP family.

How big is the High side or ing power selection PCB?

The High side or ing power selection measures 36 × 31 mm, has 4 copper layers and is 1.599 mm thick.

How many components are on the High side or ing power selection?

13 components, from 9 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the High side or ing power selection design files?

From the Tim4769/Microver repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the High side or ing power selection design in my own project?

It is published under Custom license, which limits how it may be reused; read the license before building on it.

Can I test firmware for the High side or ing power selection without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug NXP firmware against it before you order a PCB.

More boards in Microver

Similar boards