Controller

zuhayrl·EEE4022S_Thesis·PCB/Controller/controller_v2-0/controller.kicad_pcb

Controller PCB layout, top view — open source ESP32 board by zuhayrl

About the Controller PCB

Controller is an open source ESP32 PCB design by zuhayrl, published on GitHub. It is a 2-layer board measuring 55 × 70 mm, with 22 components from 13 distinct parts.

Its main chip is the ESP32-DEVKITC-32E, from the ESP32 family. Other key parts include the C6187, C8963 and C6186. By type, the board carries 9 capacitors, 5 connectors, 4 ICs and 3 resistors.

Main components on the Controller

Controller bill of materials (BOM)

22 components, 13 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ESP32-DEVKITC-32E
U1
1
C6187
AMS1117-5.0
U2
1
C8963
SP3485EN
U3
1
C6186
AMS1117-3.3
U4
1
16-Pin LCD
J1
1
PWR
J2
1
Inter Board
J3
2
CONN_01X19
Conn_01x19
J4, J5
1
LCD Pot
RV1
5
C1525
0.1uF
C1, C2, C5, C6, C9
4
C12891
22uF
C3, C4, C7, C8
2
C23162
4.7K
R1, R3
1
C22787
120
R2

Controller design files

The KiCad project lives in the zuhayrl/EEE4022S_Thesis repository on GitHub; these links point at the commit this page was built from.

Controller: common questions

What microcontroller does the Controller use?

The Controller is built around the ESP32-DEVKITC-32E, from the ESP32 family.

How big is the Controller PCB?

The Controller measures 55 × 70 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Controller?

22 components, from 13 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Controller design files?

From the zuhayrl/EEE4022S_Thesis repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Controller design in my own project?

The repository has no license, so all rights stay with zuhayrl. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Controller without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in EEE4022S_Thesis

Similar boards