HardLabs

SPECIES receiver

ARTS-Laboratory·Smart-Penetrometer-with-Edge-Computing-and-Intelligent-Embedded-Systems·SYS_DEV/Columbia/V0/V0.6/V0.6.1/base_station/receiver/hardware_design/SPECIES_receiver.kicad_pcb

SPECIES receiver PCB layout, top view — open source AVR/Arduino board by ARTS-Laboratory
Simulate this board

About the SPECIES receiver PCB

SPECIES receiver is an open source AVR/Arduino PCB design by ARTS-Laboratory, published on GitHub under the CC-BY-SA-4.0 license. It is a 2-layer board measuring 117.6 × 56.1 mm, with 10 components from 4 distinct parts.

Its main chip is the Nano 1, from the AVR/Arduino family. Other key parts include the Nano 2. By type, the board carries 6 capacitors, 2 modules and 2 connectors.

It belongs with the sensors designs in this gallery.

From the project

Design and development of a deployable UAV smart penetrometer

SPECIES receiver, from the project README
From the project README

Main components on the SPECIES receiver

Nano 1Nano 2

SPECIES receiver bill of materials (BOM)

10 components, 4 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
Nano 1
A1
1
Nano 2
A2
2
Conn_02x04_Odd_Even_MountingPin
J1, J2
6
C_Small
C1 - 100uF, C2 - 10uF, C3 - 1uF, C4 - 100uF, C5 - 10uF, C6 - 1uF

SPECIES receiver design files

The KiCad project lives in the ARTS-Laboratory/Smart-Penetrometer-with-Edge-Computing-and-Intelligent-Embedded-Systems repository on GitHub; these links point at the commit this page was built from.

SPECIES receiver: common questions

What microcontroller does the SPECIES receiver use?

The SPECIES receiver is built around the Nano 1, from the AVR/Arduino family.

How big is the SPECIES receiver PCB?

The SPECIES receiver measures 117.6 × 56.1 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the SPECIES receiver?

10 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the SPECIES receiver design files?

From the ARTS-Laboratory/Smart-Penetrometer-with-Edge-Computing-and-Intelligent-Embedded-Systems repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the SPECIES receiver design in my own project?

Yes, under the terms of its CC-BY-SA-4.0 license, which ARTS-Laboratory chose for the repository.

Can I test firmware for the SPECIES receiver without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Smart-Penetrometer-with-Edge-Computing-and-Intelligent-Embedded-Systems

Similar boards