ControlUnitInput

spotlesscoder·SmartClockHardware_ControlUnit·ControlUnit/ControlUnitInput/ControlUnitInput.kicad_pcb

ControlUnitInput PCB layout, top view — open source ESP8266 board by spotlesscoder

About the ControlUnitInput PCB

ControlUnitInput is an open source ESP8266 PCB design by spotlesscoder, published on GitHub under the CERN-OHL-1.2 license. It is a 2-layer board measuring 96.1 × 90.1 mm, with 43 components from 9 distinct parts.

Its main chip is the NodeMCU1.0(ESP-12E), from the ESP8266 family. Other key parts include the PCF8574. By type, the board carries 20 resistors, 16 switches, 4 connectors and 3 ICs.

It belongs with the displays & leds and dev boards & breakouts designs in this gallery.

From the project

This is part of the the hardware specification for my smart clock project.

This is part of the the hardware specification for my smart clock project.

The hardware consists of one device for the wake-up light functionality and another for the controls and LCD display.

The control unit with the display again, consists of 3 major parts held in one encasing

1.1) The controller for the input devices: various buttons and a PIR motion sensor. There are many buttons for quite a lot of different features. As the NodeMCU doesn't have enough pins, two PCF8574 IO expander chips are used (yes, I tried the MCP23017 but didn't like the libraries and didn't want to write a new…

Main components on the ControlUnitInput

ControlUnitInput bill of materials (BOM)

43 components, 9 distinct parts.

QtyPartRefs
1
NodeMCU1.0(ESP-12E)
U1
1
—
U2
1
PCF8574
U3
2
—
J1, J2
2
—
J3, J4
15
SW_Push
SW1, SW2, SW3, SW4, SW5, SW6, SW7, SW8 +7
1
—
SW12
4
4.7k
R1, R2, R11, R12
16
10k
R3, R4, R5, R6, R7, R8, R9, R10 +8

ControlUnitInput design files

The KiCad project lives in the spotlesscoder/SmartClockHardware_ControlUnit repository on GitHub; these links point at the commit this page was built from.

ControlUnitInput: common questions

What microcontroller does the ControlUnitInput use?

The ControlUnitInput is built around the NodeMCU1.0(ESP-12E), from the ESP8266 family.

How big is the ControlUnitInput PCB?

The ControlUnitInput measures 96.1 × 90.1 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the ControlUnitInput?

43 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the ControlUnitInput design files?

From the spotlesscoder/SmartClockHardware_ControlUnit repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the ControlUnitInput design in my own project?

Yes, under the terms of its CERN-OHL-1.2 license, which spotlesscoder chose for the repository.

Can I test firmware for the ControlUnitInput without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP8266 firmware against it before you order a PCB.

More boards in SmartClockHardware_ControlUnit

Similar boards