Radar v2
TonyStark2007·GPR_FMCW_SubGHz·Radar 2/Radar v2.kicad_pcb
About the Radar v2 PCB
Radar v2 is an open source STM32 PCB design by TonyStark2007, published on GitHub under the GPL-3.0 license. It is a 4-layer board measuring 90.2 × 40 mm, with 264 components from 79 distinct parts.
Its main chip is the STM32F405, from the STM32 family. Other key parts include the MCP4022, LT1817GN, Check_Point, SG-210STF and 5400BL15B050E. By type, the board carries 108 capacitors, 75 resistors, 51 ICs, 11 diodes, 11 inductors and 4 connectors.
From the project
This is an attempt to develop a ground penetrating FMCW radar. The operating range is 100MHz to 1000MHz, central frequency 435MHz. This is work in progress and not yet concrete.
This is an attempt to make a subGHz radar.
STM32F4 has triangular waveform generation option with its DAC and also ADF4158 is used for PLL topology. Either option can be used for waveform generation. Check schematic to populate necessary resistor values to use either mode. ADF4158 can generate pulses with some gap between each sweep. In this way N number of samples are packed and buffered over USB during this gap. Main loop runs with a FSM to check conditions of sweep. ADF4158 Muxout is generating pulse according to the sweep condition. External interrupt tracks this pulse to move between…
Main components on the Radar v2
Radar v2 bill of materials (BOM)
264 components, 79 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | MCP4022 | SOT23_6 | U1 |
| 1 | LT1817GN | SSOP16_3.9x4.9mm_P0.635mm | U2 |
| 14 | Check_Point | SolderPad_1_1.5mm_SMD_Circle | U3, U5, U10, U11, U14, U16, U24, U26 +6 |
| 1 | STM32F405 | LQFP64_10x10mm_P0.5mm | U4 |
| 1 | SG-210STF | Crystal_2.5x2mm | U6 |
| 2 | 5400BL15B050E | Balun_5400BL15B050E | U7, U13 |
| 1 | ADF4158 | LFCSP24_4x4mm_P0.5mm_1EXP_2.5x2.5mm | U8 |
| 1 | ADL5801 | LFCSP24_4x4mm_P0.5mm_1EXP_2.5x2.5mm | U9 |
| 1 | TLV172 | SC70_5 | U12 |
| 1 | LT6232 | SSOP16_3.9x4.9mm_P0.635mm | U15 |
| 1 | HMC431LP4 | QFN24_4x4mm_P0.5mm_1EXP_2.7x2.7mm | U17 |
| 1 | TRF37A75 | WSON8_2x2mm_P0.5mm_1EXP_0.9x1.6mm | U18 |
| 2 | PAT1220-C-6DB | PAT1220_6dB | U19, U27 |
| 1 | SKY65404 | SKY65404_31 | U20 |
| 1 | TQP5523 | QFN20_4x4mm_P0.5mm_1EXP_2.5x2.5mm | U21 |
| 2 | SMA_Connector | SMA_Connector | U22, U30 |
| 5 | MITERED_BEND | Mitered_Bend_0.33mm_90 | U23, U28, U42, U43, U44 |
| 1 | ADC_Connector | SolderPad_1_1.5mm_SMD_Circle | U25 |
| 1 | Directional_Coupler | Directional_Coupler_15dB | U29 |
| 2 | AP3211 | SOT23_6 | U31, U32 |
Show 59 more
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 2 | LDS3985 | SOT23_5 | U33, U38 |
| 1 | LP298XS | SOT23_5 | U35 |
| 1 | MicroCard | MICROCARD_DM3AT_SF_PEJM5 | U37 |
| 1 | MAX1426 | SSOP28_5.3x10.2mm_P0.65mm | U45 |
| 5 | Check_Point | SolderPad_1_1.2mm_SMD_Circle | U47, U48, U49, U50, U51 |
| 1 | 8MHz | Crystal_3.2x2.5mm | Y1 |
| 1 | Connector_01x03 | PinHeader_1x3_P2.5mm | J1 |
| 1 | USB_MicroB | USB_MicroB_TH | J2 |
| 1 | Connector_01x06 | PinHeader_1x6_P2.5mm | J3 |
| 1 | DC_Jack | BarrelJack | J4 |
| 1 | Fuse | SMD_0805 | F1 |
| 1 | DFU_Button | Button_B3U_1000P | SW1 |
| 1 | Reset_Button | Button_B3U_1000P | SW2 |
| 2 | Diode_Schottky | Diode_SDM2U30CSP_7 | D1, D2 |
| 9 | Led_Diode | Diode_0603 | D3, D4, D5, D6, D7, D8, D9, D10 +1 |
| 5 | BLM18PG181SN1D | SMD_0603 | L1, L4, L5, L8, L9 |
| 2 | 2.2uH | SMD_0603 | L2, L3 |
| 1 | LQW18ANR10J00D | SMD_0603 | L6 |
| 1 | 0.6nH | SMD_0402 | L7 |
| 2 | 4.7uH | SMD_0805 | L10, L11 |
| 41 | 100nF | SMD_0402 | C1, C2, C3, C4, C7, C8, C10, C20 +33 |
| 12 | 10uF | SMD_0603 | C5, C12, C63, C64, C89, C91, C92, C95 +4 |
| 6 | 2.2uF | SMD_0402 | C6, C11, C14, C15, C21, C69 |
| 2 | 33pF | SMD_0402 | C9, C13 |
| 2 | 15pF | SMD_0402 | C16, C17 |
| 2 | 1uF | SMD_0402 | C18, C19 |
| 7 | 100pF | SMD_0402 | C24, C25, C45, C47, C48, C53, C79 |
| 1 | 470pF | SMD_0402 | C33 |
| 3 | 18pF | SMD_0402 | C37, C38, C42 |
| 8 | 10pF | SMD_0402 | C39, C40, C52, C60, C61, C67, C68, C76 |
| 1 | 330nF | SMD_0402 | C55 |
| 11 | 10nF | SMD_0402 | C57, C73, C74, C75, C77, C78, C93, C94 +3 |
| 1 | 2.2nF | SMD_0402 | C62 |
| 2 | DNP | SMD_0402 | C65, C71 |
| 4 | 1nF | SMD_0402 | C72, C81, C82, C90 |
| 1 | 0.5pF | SMD_0402 | C83 |
| 4 | 2.2uF | SMD_0603 | C104, C105, C106, C108 |
| 18 | 1K | SMD_0402 | R1, R10, R13, R20, R30, R39, R40, R46 +10 |
| 5 | 0 | SMD_0402 | R2, R3, R24, R33, R35 |
| 4 | 22 | SMD_0402 | R5, R6, R12, R74 |
| 4 | 100 | SMD_0402 | R7, R8, R16, R76 |
| 2 | 2.49K | SMD_0402 | R9, R11 |
| 1 | 49.9 | SMD_0402 | R14 |
| 8 | DNP | SMD_0402 | R15, R23, R27, R28, R31, R72, R73, R75 |
| 5 | 4.7K | SMD_0402 | R17, R19, R36, R37, R63 |
| 8 | 10K | SMD_0402 | R18, R21, R22, R41, R42, R61, R64, R65 |
| 3 | 50 | SMD_0402 | R25, R29, R59 |
| 1 | 5.49K | SMD_0402 | R26 |
| 1 | 240 | SMD_0402 | R32 |
| 1 | 100K | SMD_0402 | R38 |
| 1 | 1.8 | SMD_0402 | R43 |
| 2 | 910 | SMD_0402 | R44, R45 |
| 2 | 130 | SMD_0402 | R47, R48 |
| 2 | 4.99K | SMD_0402 | R50, R51 |
| 3 | 16.7 | SMD_0402 | R52, R77, R78 |
| 1 | 0 to 27 | SMD_0402 | R57 |
| 1 | 30K | SMD_0402 | R58 |
| 1 | 51.4K | SMD_0402 | R60 |
| 1 | 14.7K | SMD_0402 | R62 |
Radar v2 design files
The KiCad project lives in the TonyStark2007/GPR_FMCW_SubGHz repository on GitHub; these links point at the commit this page was built from.
Radar v2: common questions
What microcontroller does the Radar v2 use?
The Radar v2 is built around the STM32F405, from the STM32 family.
How big is the Radar v2 PCB?
The Radar v2 measures 90.2 × 40 mm, has 4 copper layers and is 1.6 mm thick.
How many components are on the Radar v2?
264 components, from 79 distinct parts. The full bill of materials is listed on this page.
Where can I download the Radar v2 design files?
From the TonyStark2007/GPR_FMCW_SubGHz repository on GitHub, which has the KiCad layout; the links under Design files point to each one.
Can I use the Radar v2 design in my own project?
Yes, under the terms of its GPL-3.0 license, which TonyStark2007 chose for the repository.
Can I test firmware for the Radar v2 without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.
More boards in GPR_FMCW_SubGHz
Similar boards
STM32
LumenPnP Motherboard
opulo-inc
149 × 95 mm296 parts4LCC-BY-SA-4.03.7kSTM32
AxxSolder
AxxAxx
39 × 82.5 mm122 parts2LGPL-3.01.7kSTM32
LibreVNA
jankae
122 × 98 mm592 parts6LGPL-3.01.6kSTM32
AIOC
skuep
21 × 31.5 mm47 parts2LMIT1.4kSTM32
Ferris
pierrechevalier83
208.8 × 86.8 mm102 parts2LSHL-2.11.3kSTM32
176 pin board
rusefi
61.8 × 73.2 mm76 parts2LGPL-3.01.2k