RTC RELAY

zen451019·EMASA_drivers·Schematics/RTC_RELAY/RTC_RELAY.kicad_pcb

RTC RELAY PCB layout, top view — open source RP2040/RP2350 board by zen451019

About the RTC RELAY PCB

RTC RELAY is an open source RP2040/RP2350 PCB design by zen451019, published on GitHub. It is a 2-layer board measuring 125 × 100 mm, with 51 components from 16 distinct parts.

Its main chip is the RaspberryPi_Pico, from the RP2040/RP2350 family. Other key parts include the 74HC595, ULN2803A, PC817 and YAAJ_DCDC_StepDown_LM2596. By type, the board carries 19 ICs, 19 resistors, 3 capacitors, 2 diodes, 1 module and 1 connector.

From the project

Compendium of codes, schematics, and controller boards designed for use by EMASA

Main components on the RTC RELAY

RTC RELAY bill of materials (BOM)

51 components, 16 distinct parts.

QtyPartRefs
1
74HC595
U2
1
ULN2803A
U3
16
PC817
U4, U5, U6, U7, U8, U9, U10, U11 +8
1
YAAJ_DCDC_StepDown_LM2596
U20
1
RaspberryPi_Pico
A1
1
Conn_01x02_Pin
J1
1
Screw_Terminal_01x02
24_IN1
1
Conn_01x04
I2C_OUT1
3
Screw_Terminal_01x10
Input_1, Input_2, Output1
1
RTC_DS3231
RTC1
2
SS34
D1, D3
2
100nF
C2, C5
1
470 uF
C3
16
2.2K
R0, R1, R2, R3, R4, R5, R6, R7 +8
2
4.7K
R16, R17
1
10 K
R18

RTC RELAY design files

The KiCad project lives in the zen451019/EMASA_drivers repository on GitHub; these links point at the commit this page was built from.

RTC RELAY: common questions

What microcontroller does the RTC RELAY use?

The RTC RELAY is built around the RaspberryPi_Pico, from the RP2040/RP2350 family.

How big is the RTC RELAY PCB?

The RTC RELAY measures 125 × 100 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the RTC RELAY?

51 components, from 16 distinct parts. The full bill of materials is listed on this page.

Where can I download the RTC RELAY design files?

From the zen451019/EMASA_drivers repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the RTC RELAY design in my own project?

The repository has no license, so all rights stay with zen451019. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the RTC RELAY without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

More boards in EMASA_drivers

Similar boards