HardLabs

Panel proto tracking comparator board

PantsForBirds·adsbee·kicad/prototyping/panel_proto_tracking_comparator_board/panel_proto_tracking_comparator_board.kicad_pcb

Panel proto tracking comparator board layout, top view — open source board by PantsForBirds
Simulate this board

About the Panel proto tracking comparator board

Panel proto tracking comparator board is an open source PCB design by PantsForBirds, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 68 × 45 mm, with 8 components from 6 distinct parts.

By type, the board carries 4 resistors, 2 diodes and 2 capacitors.

It belongs with the rf & radio and dev boards & breakouts designs in this gallery.

From the project

Open Source Embedded ADS-B Receiver

ADSBee is a family of open-source, dual-band ADS-B receivers from Pants for Birds LLC. Every ADSBee decodes 1090 MHz Mode S / ADS-B and 978 MHz UAT transmissions onboard — no SDR dongle, FPGA, or host computer required — maintains an aircraft dictionary, and streams tracked aircraft over UART (and, on the 1090 family, WiFi / Ethernet) in a wide range of output protocols. This repository holds the firmware, hardware design files, datasheets, and host software for the whole family.

Panel proto tracking comparator board, from the project README
From the project README

Panel proto tracking comparator board bill of materials (BOM)

8 components, 6 distinct parts.

QtyPartRefs
2
D_Schottky
D1, D2
1
0.1uF
C1
1
1nF
C3
1
10k
R1
2
100k
R2, R5
1
200k
R7

Panel proto tracking comparator board design files

The KiCad project lives in the PantsForBirds/adsbee repository on GitHub; these links point at the commit this page was built from.

Panel proto tracking comparator board: common questions

How big is the Panel proto tracking comparator board?

The Panel proto tracking comparator board measures 68 × 45 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Panel proto tracking comparator board?

8 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Panel proto tracking comparator board design files?

From the PantsForBirds/adsbee repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Panel proto tracking comparator board design in my own project?

Yes, under the terms of its GPL-3.0 license, which PantsForBirds chose for the repository.

More boards in adsbee

Similar boards