HardLabs

Proto ads bee rf board

PantsForBirds·adsbee·kicad/prototyping/proto_ads_bee_rf_board/proto_ads_bee_rf_board.kicad_pcb

Proto ads bee rf board layout, top view — open source board by PantsForBirds
Simulate this board

About the Proto ads bee rf board

Proto ads bee rf board is an open source PCB design by PantsForBirds, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 44 × 28 mm, with 16 components from 9 distinct parts.

Other key parts include the AZ1117-3.3 and BGA2818. By type, the board carries 8 capacitors, 3 connectors, 2 ICs, 2 crystals and 1 diode.

It belongs with the rf & radio and dev boards & breakouts designs in this gallery.

From the project

Open Source Embedded ADS-B Receiver

ADSBee is a family of open-source, dual-band ADS-B receivers from Pants for Birds LLC. Every ADSBee decodes 1090 MHz Mode S / ADS-B and 978 MHz UAT transmissions onboard — no SDR dongle, FPGA, or host computer required — maintains an aircraft dictionary, and streams tracked aircraft over UART (and, on the 1090 family, WiFi / Ethernet) in a wide range of output protocols. This repository holds the firmware, hardware design files, datasheets, and host software for the whole family.

Proto ads bee rf board, from the project README
From the project README

Main components on the Proto ads bee rf board

AZ1117-3.3BGA2818

Proto ads bee rf board bill of materials (BOM)

16 components, 9 distinct parts.

QtyPartRefs
1
AZ1117-3.3
U1
1
BGA2818
U2
2
SF2321D
X1, X2
2
132289
Conn_Coaxial
J1, J6
1
Conn_01x02_Male
J2
1
1N5819
40V 1A
D1
1
22nF
C1
3
10uF
C2, C6, C7
4
39pF
C3, C4, C5, C8

Proto ads bee rf board design files

The KiCad project lives in the PantsForBirds/adsbee repository on GitHub; these links point at the commit this page was built from.

Proto ads bee rf board: common questions

How big is the Proto ads bee rf board?

The Proto ads bee rf board measures 44 × 28 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Proto ads bee rf board?

16 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Proto ads bee rf board design files?

From the PantsForBirds/adsbee repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Proto ads bee rf board design in my own project?

Yes, under the terms of its GPL-3.0 license, which PantsForBirds chose for the repository.

More boards in adsbee

Similar boards