HardLabs

Proto data slicer board

PantsForBirds·adsbee·kicad/prototyping/proto_data_slicer_board/proto_data_slicer_board.kicad_pcb

Proto data slicer board layout, top view — open source board by PantsForBirds

About the Proto data slicer board

Proto data slicer board is an open source PCB design by PantsForBirds, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 14 × 12.5 mm, with 13 components from 8 distinct parts.

Other key parts include the MCP6566. By type, the board carries 8 resistors, 4 capacitors and 1 IC.

It belongs with the rf & radio and dev boards & breakouts designs in this gallery.

From the project

Open Source Embedded ADS-B Receiver

ADSBee is a family of open-source, dual-band ADS-B receivers from Pants for Birds LLC. Every ADSBee decodes 1090 MHz Mode S / ADS-B and 978 MHz UAT transmissions onboard — no SDR dongle, FPGA, or host computer required — maintains an aircraft dictionary, and streams tracked aircraft over UART (and, on the 1090 family, WiFi / Ethernet) in a wide range of output protocols. This repository holds the firmware, hardware design files, datasheets, and host software for the whole family.

Proto data slicer board, from the project README
From the project README

Main components on the Proto data slicer board

MCP6566

Proto data slicer board bill of materials (BOM)

13 components, 8 distinct parts.

QtyPartRefs
1
MCP6566
U1
1
100pF
C1
1
0.1uF
C2
1
3pF
C3
1
10nF
C4
3
10k
R1, R3, R4
2
1M
R2, R5
3
1k
R6, R7, R8

Proto data slicer board design files

The KiCad project lives in the PantsForBirds/adsbee repository on GitHub; these links point at the commit this page was built from.

Proto data slicer board: common questions

How big is the Proto data slicer board?

The Proto data slicer board measures 14 × 12.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Proto data slicer board?

13 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Proto data slicer board design files?

From the PantsForBirds/adsbee repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Proto data slicer board design in my own project?

Yes, under the terms of its GPL-3.0 license, which PantsForBirds chose for the repository.

More boards in adsbee

Similar boards