HardLabs

Proto lna board

PantsForBirds·adsbee·kicad/prototyping/proto_lna_board/proto_lna_board.kicad_pcb

Proto lna board layout, top view — open source board by PantsForBirds
Simulate this board

About the Proto lna board

Proto lna board is an open source PCB design by PantsForBirds, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 23 × 11 mm, with 12 components from 9 distinct parts.

Other key parts include the BLB01. By type, the board carries 5 capacitors, 2 connectors, 2 inductors, 2 resistors and 1 IC.

It belongs with the rf & radio and dev boards & breakouts designs in this gallery.

From the project

Open Source Embedded ADS-B Receiver

ADSBee is a family of open-source, dual-band ADS-B receivers from Pants for Birds LLC. Every ADSBee decodes 1090 MHz Mode S / ADS-B and 978 MHz UAT transmissions onboard — no SDR dongle, FPGA, or host computer required — maintains an aircraft dictionary, and streams tracked aircraft over UART (and, on the 1090 family, WiFi / Ethernet) in a wide range of output protocols. This repository holds the firmware, hardware design files, datasheets, and host software for the whole family.

Proto lna board, from the project README
From the project README

Main components on the Proto lna board

BLB01

Proto lna board bill of materials (BOM)

12 components, 9 distinct parts.

QtyPartRefs
1
BLB01
U1
2
SMA Female Edge Mount
J1, J2
1
C408697
27nH RF
L1
1
C54972
82nH RF
L2
1
C60474
0.1uF
C1
2
C326662
12pF
C2, C5
2
C106200
100pF
C3, C4
1
C93940
6.8k
R1
1
C60485
0R
R2

Proto lna board design files

The KiCad project lives in the PantsForBirds/adsbee repository on GitHub; these links point at the commit this page was built from.

Proto lna board: common questions

How big is the Proto lna board?

The Proto lna board measures 23 × 11 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Proto lna board?

12 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Proto lna board design files?

From the PantsForBirds/adsbee repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Proto lna board design in my own project?

Yes, under the terms of its GPL-3.0 license, which PantsForBirds chose for the repository.

More boards in adsbee

Similar boards