HardLabs

Proto ufl match board

PantsForBirds·adsbee·kicad/prototyping/proto_ufl_match_board/proto_ufl_match_board.kicad_pcb

Proto ufl match board layout, top view — open source board by PantsForBirds
Simulate this board

About the Proto ufl match board

Proto ufl match board is an open source PCB design by PantsForBirds, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 23 × 8 mm, with 7 components from 2 distinct parts.

By type, the board carries 5 resistors and 2 connectors.

It belongs with the rf & radio and dev boards & breakouts designs in this gallery.

From the project

Open Source Embedded ADS-B Receiver

ADSBee is a family of open-source, dual-band ADS-B receivers from Pants for Birds LLC. Every ADSBee decodes 1090 MHz Mode S / ADS-B and 978 MHz UAT transmissions onboard — no SDR dongle, FPGA, or host computer required — maintains an aircraft dictionary, and streams tracked aircraft over UART (and, on the 1090 family, WiFi / Ethernet) in a wide range of output protocols. This repository holds the firmware, hardware design files, datasheets, and host software for the whole family.

Proto ufl match board, from the project README
From the project README

Proto ufl match board bill of materials (BOM)

7 components, 2 distinct parts.

QtyPartRefs
2
U.FL-R-SMT-1(10)
Conn_Coaxial
J1, J2
5
R_US
R1, R2, R3, R4, R5

Proto ufl match board design files

The KiCad project lives in the PantsForBirds/adsbee repository on GitHub; these links point at the commit this page was built from.

Proto ufl match board: common questions

How big is the Proto ufl match board?

The Proto ufl match board measures 23 × 8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Proto ufl match board?

7 components, from 2 distinct parts. The full bill of materials is listed on this page.

Where can I download the Proto ufl match board design files?

From the PantsForBirds/adsbee repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Proto ufl match board design in my own project?

Yes, under the terms of its GPL-3.0 license, which PantsForBirds chose for the repository.

More boards in adsbee

Similar boards