HardLabs

Panel saw eval board

PantsForBirds·adsbee·kicad/prototyping/panel_saw_eval_board/panel_saw_eval_board.kicad_pcb

Panel saw eval board layout, top view — open source board by PantsForBirds

About the Panel saw eval board

Panel saw eval board is an open source PCB design by PantsForBirds, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 57 × 44 mm, with 3 components from 2 distinct parts.

By type, the board carries 2 connectors and 1 crystal.

It belongs with the dev boards & breakouts and rf & radio designs in this gallery.

From the project

Open Source Embedded ADS-B Receiver

ADSBee is a family of open-source, dual-band ADS-B receivers from Pants for Birds LLC. Every ADSBee decodes 1090 MHz Mode S / ADS-B and 978 MHz UAT transmissions onboard — no SDR dongle, FPGA, or host computer required — maintains an aircraft dictionary, and streams tracked aircraft over UART (and, on the 1090 family, WiFi / Ethernet) in a wide range of output protocols. This repository holds the firmware, hardware design files, datasheets, and host software for the whole family.

Panel saw eval board, from the project README
From the project README

Panel saw eval board bill of materials (BOM)

3 components, 2 distinct parts.

QtyPartRefs
1
SAW-6 Filter
X1
2
SMA F Board Edge Mount
J1, J2

Panel saw eval board design files

The KiCad project lives in the PantsForBirds/adsbee repository on GitHub; these links point at the commit this page was built from.

Panel saw eval board: common questions

How big is the Panel saw eval board?

The Panel saw eval board measures 57 × 44 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Panel saw eval board?

3 components, from 2 distinct parts. The full bill of materials is listed on this page.

Where can I download the Panel saw eval board design files?

From the PantsForBirds/adsbee repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Panel saw eval board design in my own project?

Yes, under the terms of its GPL-3.0 license, which PantsForBirds chose for the repository.

More boards in adsbee

Similar boards