HardLabs

Garagentor LEDs

SmartHome-yourself·shys-collection·templates/hardware/garage-door-with-rgb-led/kicad/Garagentor_LEDs.kicad_pcb

Garagentor LEDs PCB layout, top view — open source ESP8266 board by SmartHome-yourself
Simulate this board

About the Garagentor LEDs PCB

Garagentor LEDs is an open source ESP8266 PCB design by SmartHome-yourself, published on GitHub under the GPL-2.0 license. It is a 2-layer board measuring 54.6 × 63.5 mm, with 15 components from 13 distinct parts.

Its main chip is the WeMos_D1_mini, from the ESP8266 family. Other key parts include the 4ch_levelshifter_bidir_BOB-12009. By type, the board carries 8 connectors, 4 resistors, 2 ICs and 1 capacitor.

It belongs with the iot & wireless designs in this gallery.

From the project

Die Platine findet Ihr auch bei ELECROW.com unter folgendem Link: https://www.elecrow.com/sharepj/smart-garage-door-control-with-animated-rgb-led-804.html

Garagentor LEDs, from the project README
From the project README

Main components on the Garagentor LEDs

4ch_levelshifter_bidir_BOB-12009WeMos_D1_mini

Garagentor LEDs bill of materials (BOM)

15 components, 13 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
4ch_levelshifter_bidir_BOB-12009
U1
1
WeMos_D1_mini
U2
1
Reed Sensor Oben
J1
1
Reed Sensor Unten
J2
1
Tor Taster
J3
1
LED-Stripe
J4
1
Relais
J5
1
5V In
J6
1
Pinout
J7
1
TX/RX
J8
1
16V 1000uF
C1
3
10k
R1, R2, R3
1
62
R4

Garagentor LEDs design files

The KiCad project lives in the SmartHome-yourself/shys-collection repository on GitHub; these links point at the commit this page was built from.

Garagentor LEDs: common questions

What microcontroller does the Garagentor LEDs use?

The Garagentor LEDs is built around the WeMos_D1_mini, from the ESP8266 family.

How big is the Garagentor LEDs PCB?

The Garagentor LEDs measures 54.6 × 63.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Garagentor LEDs?

15 components, from 13 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Garagentor LEDs design files?

From the SmartHome-yourself/shys-collection repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Garagentor LEDs design in my own project?

Yes, under the terms of its GPL-2.0 license, which SmartHome-yourself chose for the repository.

Can I test firmware for the Garagentor LEDs without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP8266 firmware against it before you order a PCB.

More boards in shys-collection

Similar boards