KeyboardEncoder

stefanhepp·eOrgan·boards/KeyboardEncoder/KeyboardEncoder.kicad_pcb

KeyboardEncoder PCB layout, top view — open source AVR/Arduino board by stefanhepp

About the KeyboardEncoder PCB

KeyboardEncoder is an open source AVR/Arduino PCB design by stefanhepp, published on GitHub under the CC-BY-SA-4.0 license. It is a 2-layer board measuring 150 × 100 mm, with 26 components from 20 distinct parts.

Its main chip is the ATmega48-20P, from the AVR/Arduino family. Other key parts include the 6N137, L7805 and 74LS07. By type, the board carries 7 connectors, 7 capacitors, 6 resistors, 4 ICs and 1 diode.

It belongs with the audio and displays & leds designs in this gallery.

From the project

Electronic organ console project.

This project contains various parts of a midi-organ. The project consists of four main parts:

- The Pedalboard: a 29 note midi foot pedal, mostly ARGO compliant. This odd number of notes was choosen because of size restrictions (I wanted it to fit under my e-piano). - The organ console: contains stops, a lcd display, and all connectors and hardware to wire it to a PC. Up to three midi keyboards can be used as input devices, as well as the midi pedalboard. - The organ desk: a framework for all the parts, contains speakers and some additional foot-stops. This is also designed to hold the PC. -…

Main components on the KeyboardEncoder

KeyboardEncoder bill of materials (BOM)

26 components, 20 distinct parts.

QtyPartRefs
1
ATmega48-20P
U1
1
6N137
U2
1
L7805
U4
1
74LS07
U5
1
ISP
J1
1
Encoder
J2
1
MIDI Out
J3
1
SelectRX
J4
1
MIDI In
J5
1
BoardCon
J7
1
PistonEncoder
J8
1
Heatsink_Pad
HS1
1
1N4148
D1
4
100nF
C1, C2, C4, C5
1
33uF
C3
1
10uF
C6
1
330nF
C7
1
1k
R1
4
220
R3, R4, R5, R6
1
10k
RN1

KeyboardEncoder design files

The KiCad project lives in the stefanhepp/eOrgan repository on GitHub; these links point at the commit this page was built from.

KeyboardEncoder: common questions

What microcontroller does the KeyboardEncoder use?

The KeyboardEncoder is built around the ATmega48-20P, from the AVR/Arduino family.

How big is the KeyboardEncoder PCB?

The KeyboardEncoder measures 150 × 100 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the KeyboardEncoder?

26 components, from 20 distinct parts. The full bill of materials is listed on this page.

Where can I download the KeyboardEncoder design files?

From the stefanhepp/eOrgan repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the KeyboardEncoder design in my own project?

Yes, under the terms of its CC-BY-SA-4.0 license, which stefanhepp chose for the repository.

Can I test firmware for the KeyboardEncoder without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in eOrgan

Similar boards