TechnicsEncoder

stefanhepp·eOrgan·boards/TechnicsEncoder/TechnicsEncoder.kicad_pcb

TechnicsEncoder PCB layout, top view — open source AVR/Arduino board by stefanhepp

About the TechnicsEncoder PCB

TechnicsEncoder is an open source AVR/Arduino PCB design by stefanhepp, published on GitHub under the CC-BY-SA-4.0 license. It is a 2-layer board measuring 110 × 53 mm, with 28 components from 22 distinct parts.

Its main chip is the ATmega48-20P, from the AVR/Arduino family. Other key parts include the 6N137, L7805 and 74LS07. By type, the board carries 8 connectors, 8 resistors, 6 capacitors, 4 ICs and 1 diode.

It belongs with the audio and displays & leds designs in this gallery.

From the project

Electronic organ console project.

This project contains various parts of a midi-organ. The project consists of four main parts:

- The Pedalboard: a 29 note midi foot pedal, mostly ARGO compliant. This odd number of notes was choosen because of size restrictions (I wanted it to fit under my e-piano). - The organ console: contains stops, a lcd display, and all connectors and hardware to wire it to a PC. Up to three midi keyboards can be used as input devices, as well as the midi pedalboard. - The organ desk: a framework for all the parts, contains speakers and some additional foot-stops. This is also designed to hold the PC. -…

Main components on the TechnicsEncoder

TechnicsEncoder bill of materials (BOM)

28 components, 22 distinct parts.

QtyPartRefs
1
ATmega48-20P
U1
1
6N137
U2
1
L7805
U4
1
74LS07
U5
1
ISP
J1
1
Bender
J2
1
Technics
J3
1
SelectRX
J4
1
MIDI In
J5
1
MIDI Out
J6
1
BoardCon
J7
1
PistonEncoder
J8
1
Heatsink_Pad
HS1
1
1N4148
D1
3
100nF
C1, C2, C7
1
330nF
C3
1
33uF
C5
1
10uF
C6
1
2k2
R1
2
220
R4, R6
Show 2 more
QtyPartRefs
2
220
R5, R7
3
220
RN1, RN2, RN3

TechnicsEncoder design files

The KiCad project lives in the stefanhepp/eOrgan repository on GitHub; these links point at the commit this page was built from.

TechnicsEncoder: common questions

What microcontroller does the TechnicsEncoder use?

The TechnicsEncoder is built around the ATmega48-20P, from the AVR/Arduino family.

How big is the TechnicsEncoder PCB?

The TechnicsEncoder measures 110 × 53 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the TechnicsEncoder?

28 components, from 22 distinct parts. The full bill of materials is listed on this page.

Where can I download the TechnicsEncoder design files?

From the stefanhepp/eOrgan repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the TechnicsEncoder design in my own project?

Yes, under the terms of its CC-BY-SA-4.0 license, which stefanhepp chose for the repository.

Can I test firmware for the TechnicsEncoder without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in eOrgan

Similar boards