MiAM PAMI StepperShield

14chanwa·MiAM_robotics_ESP32·Electronics/eurobot2023/MiAM_PAMI_StepperShield/MiAM_PAMI_StepperShield.kicad_pcb

MiAM PAMI StepperShield PCB layout, top view — open source ESP32 board by 14chanwa

About the MiAM PAMI StepperShield PCB

MiAM PAMI StepperShield is an open source ESP32 PCB design by 14chanwa, published on GitHub. It is a 2-layer board measuring 43.7 × 54.2 mm, with 18 components from 11 distinct parts.

Its main chip is the ESP32-DEVKIT-V1, from the ESP32 family. Other key parts include the Pololu_Breakout_A4988. By type, the board carries 2 modules, 2 capacitors, 1 IC and 1 connector.

It belongs with the robotics & motion designs in this gallery.

From the project

MiAM robotics repository for ESP32 based PAMIs and boards

Main components on the MiAM PAMI StepperShield

MiAM PAMI StepperShield bill of materials (BOM)

18 components, 11 distinct parts.

QtyPartRefs
1
ESP32-DEVKIT-V1
U1
2
Pololu_Breakout_A4988
A1, A2
1
Conn_01x05_Male
J2
1
Screw_Terminal_01x02
BAT1
3
Conn_01x02_Male
EMGBUT1, PSW1, UART1
1
~
GPIO1
1
Conn_02x04_Odd_Even
I2C1
2
Conn_01x04_Male
MOT1, MOT2
3
SolderJumper_2_Open
MS1, MS2, MS3
1
Conn_02x03_Odd_Even
SRV1
2
100uF
C1, C2

MiAM PAMI StepperShield design files

The KiCad project lives in the 14chanwa/MiAM_robotics_ESP32 repository on GitHub; these links point at the commit this page was built from.

MiAM PAMI StepperShield: common questions

What microcontroller does the MiAM PAMI StepperShield use?

The MiAM PAMI StepperShield is built around the ESP32-DEVKIT-V1, from the ESP32 family.

How big is the MiAM PAMI StepperShield PCB?

The MiAM PAMI StepperShield measures 43.7 × 54.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the MiAM PAMI StepperShield?

18 components, from 11 distinct parts. The full bill of materials is listed on this page.

Where can I download the MiAM PAMI StepperShield design files?

From the 14chanwa/MiAM_robotics_ESP32 repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the MiAM PAMI StepperShield design in my own project?

The repository has no license, so all rights stay with 14chanwa. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the MiAM PAMI StepperShield without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in MiAM_robotics_ESP32

Similar boards