1 open source board using the Fuse Holder
Real designs built with the Fuse Holder, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
xtechThe Fuse Holder in open source designs
The gallery holds 1 open source boards using the Fuse Holder from 1 GitHub repository; a typical one measures about 180 × 170 mm and carries around 275 components.
100% use four copper layers or more, and 100% carry an open source license.
The most starred is Hw openmower yardforce by xtech.
Microcontrollers on boards using the Fuse Holder
What boards using the Fuse Holder are built for
Fuse Holder: common questions
Where can I find a Fuse Holder reference design?
Each of the 1 boards on this page is a real design using the Fuse Holder. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the Fuse Holder use?
Most are built on AVR/Arduino (1).
How big is a typical board using the Fuse Holder?
The median is 180 × 170 mm, and 0% are two-layer designs.
What is the most popular open source board using the Fuse Holder?
By GitHub stars, Hw openmower yardforce by xtech, with 12 stars.
Can I simulate one of these boards using the Fuse Holder before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.