1 open source board using the XT-30
Real designs built with the XT-30, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
OSHE-GithubThe XT-30 in open source designs
The gallery holds 1 open source boards using the XT-30 from 1 GitHub repository; a typical one measures about 67.8 × 82.7 mm and carries around 93 components.
100% use four copper layers or more, and 0% carry an open source license.
The most starred is Envelope follower kicad by OSHE-Github.
What boards using the XT-30 are built for
XT-30: common questions
Where can I find a XT-30 reference design?
Each of the 1 boards on this page is a real design using the XT-30. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
How big is a typical board using the XT-30?
The median is 67.8 × 82.7 mm, and 0% are two-layer designs.
What is the most popular open source board using the XT-30?
By GitHub stars, Envelope follower kicad by OSHE-Github, with 1 stars.
Can I simulate one of these boards using the XT-30 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.