3 open source boards using the ADS7128IRTER
Real designs built with the ADS7128IRTER, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
Raspberry Pi
Lamoka1/2
bearjhartjen122.7 × 124.8 mm126 parts2LCERN-OHL-W-2.07ESP32
Riskybirdv3
ucb-bar
58.3 × 58.3 mm172 parts4LNo license2Raspberry Pi
Cm5-carrier v2
ben5049
70 × 80 mm294 parts6LAGPL-3.01
The ADS7128IRTER in open source designs
The gallery holds 3 open source boards using the ADS7128IRTER from 3 GitHub repositories; a typical one measures about 70 × 80 mm and carries around 172 components.
67% use four copper layers or more, and 67% carry an open source license.
The most starred is Lamoka1/2 by bearjhartjen.
Microcontrollers on boards using the ADS7128IRTER
What boards using the ADS7128IRTER are built for
ADS7128IRTER: common questions
Where can I find a ADS7128IRTER reference design?
Each of the 3 boards on this page is a real design using the ADS7128IRTER. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the ADS7128IRTER use?
Most are built on Raspberry Pi (2) and ESP32 (1).
How big is a typical board using the ADS7128IRTER?
The median is 70 × 80 mm, and 33% are two-layer designs.
What is the most popular open source board using the ADS7128IRTER?
By GitHub stars, Lamoka1/2 by bearjhartjen, with 7 stars.
Can I simulate one of these boards using the ADS7128IRTER before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.