2 open source boards using the DIP
Real designs built with the DIP, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
Nordic nRFBabyMonitor
kparham0216
88.4 × 65 mm64 parts2LNo license0
SignleCellBoard
hughe349
95.3 × 105.4 mm37 parts2LGPL-3.02
The DIP in open source designs
The gallery holds 2 open source boards using the DIP from 2 GitHub repositories; a typical one measures about 91.8 × 85.2 mm and carries around 51 components.
100% are two-layer designs, the rest use four layers or more, and 50% carry an open source license.
The most starred is SignleCellBoard by hughe349.
Microcontrollers on boards using the DIP
What boards using the DIP are built for
DIP: common questions
Where can I find a DIP reference design?
Each of the 2 boards on this page is a real design using the DIP. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the DIP use?
Most are built on Nordic nRF (1).
How big is a typical board using the DIP?
The median is 91.8 × 85.2 mm, and 100% are two-layer designs.
What is the most popular open source board using the DIP?
By GitHub stars, SignleCellBoard by hughe349, with 2 stars.
Can I simulate one of these boards using the DIP before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.