2 open source boards using the STPMIC1
Real designs built with the STPMIC1, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
FPGA
ZYNQ Ruler
Stanlazy
88 × 23.4 mm217 parts4LLGPL-2.117Stpmic
WesleyVong
43.2 × 38.1 mm34 parts2LNo license0
The STPMIC1 in open source designs
The gallery holds 2 open source boards using the STPMIC1 from 2 GitHub repositories; a typical one measures about 65.6 × 30.7 mm and carries around 126 components.
50% are two-layer designs, the rest use four layers or more, and 50% carry an open source license.
The most starred is ZYNQ Ruler by Stanlazy.
Microcontrollers on boards using the STPMIC1
STPMIC1: common questions
Where can I find a STPMIC1 reference design?
Each of the 2 boards on this page is a real design using the STPMIC1. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the STPMIC1 use?
Most are built on FPGA (1).
How big is a typical board using the STPMIC1?
The median is 65.6 × 30.7 mm, and 50% are two-layer designs.
What is the most popular open source board using the STPMIC1?
By GitHub stars, ZYNQ Ruler by Stanlazy, with 17 stars.
Can I simulate one of these boards using the STPMIC1 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.