5 open source boards using the XT30
Real designs built with the XT30, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
STM32
Daedalus
0xJeremy
42 × 50.2 mm94 parts2LNo license2FPGA
Controller Board
MichalVarsanyi
85 × 85 mm291 parts6LMIT1FPGA
Programmer Sensor Stencil
MichalVarsanyi
85 × 15.8 mm118 parts2LMIT1VoxLink Programmer Board
MichalVarsanyi
49.1 × 15.5 mm55 parts4LMIT1FPGA
Core Module Intel
MichalVarsanyi
13 × 13 mm27 parts6LMIT1
The XT30 in open source designs
The gallery holds 5 open source boards using the XT30 from 2 GitHub repositories; a typical one measures about 49.1 × 15.8 mm and carries around 94 components.
60% use four copper layers or more, and 80% carry an open source license.
The most starred is Daedalus by 0xJeremy.
What boards using the XT30 are built for
XT30: common questions
Where can I find a XT30 reference design?
Each of the 5 boards on this page is a real design using the XT30. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the XT30 use?
Most are built on FPGA (3) and STM32 (1).
How big is a typical board using the XT30?
The median is 49.1 × 15.8 mm, and 40% are two-layer designs.
What is the most popular open source board using the XT30?
By GitHub stars, Daedalus by 0xJeremy, with 2 stars.
Can I simulate one of these boards using the XT30 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.