4 open source boards using the INA138
Real designs built with the INA138, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
RP2040/RP2350Sweep
waffle87
216.9 × 86.9 mm208 parts2LSHL-2.157
PICQI Charger
drewsum
150 × 50 mm293 parts2LNo license20
AVR/ArduinoPower Supply
adsehgal
100 × 50 mm94 parts2LNo license2
STM32Robotont electronics mainboard
robotont
304.3 × 274 mm407 parts2LNo license1
The INA138 in open source designs
The gallery holds 4 open source boards using the INA138 from 4 GitHub repositories; a typical one measures about 183.5 × 68.4 mm and carries around 251 components.
100% are two-layer designs, the rest use four layers or more, and 0% carry an open source license.
The most starred is Sweep by waffle87.
Microcontrollers on boards using the INA138
What boards using the INA138 are built for
INA138: common questions
Where can I find a INA138 reference design?
Each of the 4 boards on this page is a real design using the INA138. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the INA138 use?
Most are built on AVR/Arduino (1), PIC (1), RP2040/RP2350 (1) and STM32 (1).
How big is a typical board using the INA138?
The median is 183.5 × 68.4 mm, and 100% are two-layer designs.
What is the most popular open source board using the INA138?
By GitHub stars, Sweep by waffle87, with 57 stars.
Can I simulate one of these boards using the INA138 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.