4 open source boards using the IMU
Real designs built with the IMU, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
AVR/Arduino
MotorCape
GT-IEEE-Robotics
128.9 × 59.8 mm25 parts2LNo license3OpenGUT
OpenGUT
45.3 × 45.1 mm58 parts2LNo license0Enhanced drone flight controller
dao-genesis
110 × 85 mm50 parts2LNo license0Panel
roman-khvatov
117 × 78 mm37 parts2LMIT1
The IMU in open source designs
The gallery holds 4 open source boards using the IMU from 4 GitHub repositories; a typical one measures about 113.5 × 68.9 mm and carries around 44 components.
100% are two-layer designs, the rest use four layers or more, and 25% carry an open source license.
The most starred is MotorCape by GT-IEEE-Robotics.
Microcontrollers on boards using the IMU
What boards using the IMU are built for
IMU: common questions
Where can I find a IMU reference design?
Each of the 4 boards on this page is a real design using the IMU. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the IMU use?
Most are built on AVR/Arduino (1).
How big is a typical board using the IMU?
The median is 113.5 × 68.9 mm, and 100% are two-layer designs.
What is the most popular open source board using the IMU?
By GitHub stars, MotorCape by GT-IEEE-Robotics, with 3 stars.
Can I simulate one of these boards using the IMU before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.