5 open source boards using the INPUT
Real designs built with the INPUT, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
Adder
radiolok
203.8 × 125.6 mm16 parts2LBSD-2-Clause5Me3116 regulator
R8bert
22.1 × 49.6 mm20 parts2LNo license0Carte1
Honzaaa45
170.6 × 126.1 mm40 parts4LMIT0LGS5145 Voltage Regulator
R8bert
25 × 50 mm15 parts2LNo license0LGS5145 Voltage Regulator.sync conflict-20250314-135747-656VQ5O
R8bert
25 × 50 mm15 parts2LNo license0
The INPUT in open source designs
The gallery holds 5 open source boards using the INPUT from 3 GitHub repositories; a typical one measures about 25 × 50 mm and carries around 16 components.
80% are two-layer designs, the rest use four layers or more, and 40% carry an open source license.
The most starred is Adder by radiolok.
Parts used alongside the INPUT
INPUT: common questions
Where can I find a INPUT reference design?
Each of the 5 boards on this page is a real design using the INPUT. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
How big is a typical board using the INPUT?
The median is 25 × 50 mm, and 80% are two-layer designs.
What is the most popular open source board using the INPUT?
By GitHub stars, Adder by radiolok, with 5 stars.
Can I simulate one of these boards using the INPUT before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.