9 open source boards using the Buck Converter
Real designs built with the Buck Converter, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
STM32
BLDC-Motor-Controller-STM32
yussufadel8
85 × 65 mm128 parts2LMIT1SumoBots
Comet-Robotics
74 × 45 mm13 parts2LMIT1RP2040/RP2350
RotocasterKUL
JarneVG
100 × 83 mm56 parts2LMIT0AVR/Arduino
3lb-Melty
DylM0nster22
128 × 70 mm37 parts2LNo license0AVR/Arduino
Hexapod
GreatMesa
108.8 × 82.1 mm36 parts4LNo license0ESP32
Glasses-V.01
nicka06
29.2 × 90.2 mm31 parts2LNo license0ESP32
Pipernigrum iot
naufalyafisusanto
140.3 × 84.9 mm28 parts2LNo license0ESP32
FallSensorSystem
RajatG
100 × 80 mm21 parts2LNo license0ESP32
Chairbot
bullestock
66.9 × 100 mm30 parts2LNo license0
How designs wire the Buck Converter
Read from the KiCad layouts of 9 open source designs, one per repository: what each pin of the Buck Converter connects to, and the resistors, capacitors and other passives placed on it.
| Pin | Connected to | Parts on the pin |
|---|---|---|
| GNDpin 2 | Connected to: GND 75% · VBAT 25% | — |
4 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include SumoBots by Comet-Robotics, BLDC-Motor-Controller-STM32 by yussufadel8, Chairbot by bullestock and 3lb-Melty by DylM0nster22.
The Buck Converter in open source designs
The gallery holds 9 open source boards using the Buck Converter from 9 GitHub repositories; a typical one measures about 100 × 82.1 mm and carries around 31 components.
89% are two-layer designs, the rest use four layers or more, and 33% carry an open source license.
The most starred is BLDC-Motor-Controller-STM32 by yussufadel8.
Microcontrollers on boards using the Buck Converter
What boards using the Buck Converter are built for
Buck Converter: common questions
Where can I find a Buck Converter reference design?
Each of the 9 boards on this page is a real design using the Buck Converter. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the Buck Converter use?
Most are built on ESP32 (4), AVR/Arduino (2), RP2040/RP2350 (1) and STM32 (1).
How big is a typical board using the Buck Converter?
The median is 100 × 82.1 mm, and 89% are two-layer designs.
What is the most popular open source board using the Buck Converter?
By GitHub stars, BLDC-Motor-Controller-STM32 by yussufadel8, with 1 stars.
Can I simulate one of these boards using the Buck Converter before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.