5 open source boards using the INA230
Real designs built with the INA230, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
FPGAMarblewalrus switch
azonenberg
167.2 × 100 mm798 parts2LNo license124
STM32Linecard
185 × 93 mm611 parts6LBSD-3-Clause35
Marblewalrus backplane
203.2 × 128.7 mm189 parts4LNo license124
Pdu
105 × 47 mm38 parts4LBSD-3-Clause35
EPS Scales RevC
BroncoSpace-Lab
95.2 × 66 mm194 parts4LNo license6
The INA230 in open source designs
The gallery holds 5 open source boards using the INA230 from 3 GitHub repositories; a typical one measures about 167.1 × 93 mm and carries around 194 components.
80% use four copper layers or more, and 40% carry an open source license.
The most starred is Marblewalrus switch by azonenberg.
Parts used alongside the INA230
What boards using the INA230 are built for
INA230: common questions
Where can I find a INA230 reference design?
Each of the 5 boards on this page is a real design using the INA230. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the INA230 use?
Most are built on FPGA (1) and STM32 (1).
How big is a typical board using the INA230?
The median is 167.1 × 93 mm, and 20% are two-layer designs.
What is the most popular open source board using the INA230?
By GitHub stars, Marblewalrus switch by azonenberg, with 124 stars.
Can I simulate one of these boards using the INA230 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.