5 open source boards using the L293DD

Real designs built with the L293DD, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

5 boardsClear filters|Most starred

How designs wire the L293DD

Read from the KiCad layouts of 5 open source designs, one per repository: what each pin of the L293DD connects to, and the resistors, capacitors and other passives placed on it.

GNDpin 4, 5, 6, 7, 14, 15, 16, 17Connected to: GND 100%
VSpin 10Connected to: VCC 80% · a signal 20%
VSSpin 20Connected to: 9V 80% · a signal 20%

10 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include PSM60 Fader Controller by GadgetReboot, ESP multi board cuadrada by CRM-UAM, MotorFaderBoard by 8-Lambda-8 and Stm32 balancingRobot by JwAhn0830.

The L293DD in open source designs

The gallery holds 5 open source boards using the L293DD from 5 GitHub repositories; a typical one measures about 90.5 × 50 mm and carries around 37 components.

60% are two-layer designs, the rest use four layers or more, and 20% carry an open source license.

The most starred is PSM60 Fader Controller by GadgetReboot.

Microcontrollers on boards using the L293DD

What boards using the L293DD are built for

L293DD: common questions

Where can I find a L293DD reference design?

Each of the 5 boards on this page is a real design using the L293DD. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

Which microcontrollers do boards using the L293DD use?

Most are built on AVR/Arduino (2), ESP32 (1), ESP8266 (1) and STM32 (1).

How big is a typical board using the L293DD?

The median is 90.5 × 50 mm, and 60% are two-layer designs.

What is the most popular open source board using the L293DD?

By GitHub stars, PSM60 Fader Controller by GadgetReboot, with 8 stars.

Can I simulate one of these boards using the L293DD before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part