9 open source boards using the S2B-PH-K-S(LF)(SN)
Real designs built with the S2B-PH-K-S(LF)(SN), from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
V2
Jaydosu
430 × 117.8 mm252 parts2LNo license0Splitkeyboard v2
Anycircle11139s
312.1 × 113.9 mm128 parts2LNo license0Panel
da1sh1n
273 × 119.9 mm72 parts4LCC-BY-NC-4.00AVR/Arduino
Survivornode
aneeshlingala
56 × 75 mm16 parts2LNo license0V2.3
Jaydosu
430 × 118.4 mm252 parts2LNo license0Left
da1sh1n
137.5 × 109.3 mm65 parts4LCC-BY-NC-4.00ESP32
Envinode
aneeshlingala
62.2 × 62.2 mm14 parts2LNo license0Leftss
da1sh1n
137.5 × 109.3 mm65 parts4LCC-BY-NC-4.00Alvea keybaord right
da1sh1n
137.5 × 109.3 mm63 parts4LCC-BY-NC-4.00
The S2B-PH-K-S(LF)(SN) in open source designs
The gallery holds 9 open source boards using the S2B-PH-K-S(LF)(SN) from 4 GitHub repositories; a typical one measures about 137.5 × 109.3 mm and carries around 65 components.
56% are two-layer designs, the rest use four layers or more, and 0% carry an open source license.
The most starred is V2 by Jaydosu.
Parts used alongside the S2B-PH-K-S(LF)(SN)
Microcontrollers on boards using the S2B-PH-K-S(LF)(SN)
What boards using the S2B-PH-K-S(LF)(SN) are built for
S2B-PH-K-S(LF)(SN): common questions
Where can I find a S2B-PH-K-S(LF)(SN) reference design?
Each of the 9 boards on this page is a real design using the S2B-PH-K-S(LF)(SN). Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the S2B-PH-K-S(LF)(SN) use?
Most are built on AVR/Arduino (1) and ESP32 (1).
How big is a typical board using the S2B-PH-K-S(LF)(SN)?
The median is 137.5 × 109.3 mm, and 56% are two-layer designs.
What is the most popular open source board using the S2B-PH-K-S(LF)(SN)?
By GitHub stars, V2 by Jaydosu, with 0 stars.
Can I simulate one of these boards using the S2B-PH-K-S(LF)(SN) before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.