10 open source boards using the TLP785

Real designs built with the TLP785, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

10 boardsClear filters|Most starred

How designs wire the TLP785

Read from the KiCad layouts of 5 open source designs, one per repository: what each pin of the TLP785 connects to, and the resistors, capacitors and other passives placed on it.

  • Pin 1 has a pull-up to 3.3V on 2 of 5 designs, most often 470 Ω (then 510 Ω).
  • Pin 1 has a series resistor on 2 of 5 designs, most often 330 Ω (then 180 Ω).
Pin 1Connected to: Signal 100%
  • Pull-up to 3.3V on 40% · 470 Ω (1), 510 Ω (1)
  • Series resistor on 40% · 330 Ω (1), 180 Ω (1)

3 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Mdb bridge esp32s3 by nodestark, Car bluetooth by ChipCE, Patch board2022a by daisuke-ym and Power by Thrcot.

The TLP785 in open source designs

The gallery holds 10 open source boards using the TLP785 from 5 GitHub repositories; a typical one measures about 82.4 × 44.1 mm and carries around 52 components.

100% are two-layer designs, the rest use four layers or more, and 70% carry an open source license.

The most starred is Mdb slave esp32s3-sim7080g by nodestark.

Microcontrollers on boards using the TLP785

What boards using the TLP785 are built for

TLP785: common questions

Where can I find a TLP785 reference design?

Each of the 10 boards on this page is a real design using the TLP785. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What pull-up resistor is used on the TLP785 pin 1?

Pin 1 has a pull-up to 3.3V on 2 of 5 designs, most often 470 Ω (then 510 Ω). Counted from the KiCad layouts of 5 open source designs using the TLP785.

Which microcontrollers do boards using the TLP785 use?

Most are built on ESP32 (4) and STM32 (1).

How big is a typical board using the TLP785?

The median is 82.4 × 44.1 mm, and 100% are two-layer designs.

What is the most popular open source board using the TLP785?

By GitHub stars, Mdb slave esp32s3-sim7080g by nodestark, with 173 stars.

Can I simulate one of these boards using the TLP785 before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part