8 open source boards using the AP2171W

Real designs built with the AP2171W, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

8 boardsClear filters|Most starred

How designs wire the AP2171W

Read from the KiCad layouts of 7 open source designs, one per repository: what each pin of the AP2171W connects to, and the resistors, capacitors and other passives placed on it.

  • The OUT pin has a capacitor to GND on 7 of 7 designs, most often 100 nF (then 100 µF).
  • The IN pin is tied to 5V on 5 of 7 designs (a signal on 2).
OUTpin 1Connected to: A connector 29% · VBUS_A 43%
  • Capacitor to GND on 100% · 100 nF (5), 100 µF (2), 10 µF (2)
GNDpin 2Connected to: GND 100%
INpin 5Connected to: 5V 71% · a signal 29%

2 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Ups to esp32 by aronreid, Archer mainboard by EI2030, Elixir hw by golioth and Magna by Jaxc.

The AP2171W in open source designs

The gallery holds 8 open source boards using the AP2171W from 7 GitHub repositories; a typical one measures about 80.7 × 70.7 mm and carries around 198 components.

75% use four copper layers or more, and 88% carry an open source license.

The most starred is Ups to esp32 by aronreid.

Microcontrollers on boards using the AP2171W

AP2171W: common questions

Where can I find a AP2171W reference design?

Each of the 8 boards on this page is a real design using the AP2171W. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

How is the AP2171W OUT pin connected?

The OUT pin has a capacitor to GND on 7 of 7 designs, most often 100 nF (then 100 µF). Counted from the KiCad layouts of 7 open source designs using the AP2171W.

How is the AP2171W IN pin connected?

The IN pin is tied to 5V on 5 of 7 designs (a signal on 2). Counted from the KiCad layouts of 7 open source designs using the AP2171W.

Which microcontrollers do boards using the AP2171W use?

Most are built on ESP32 (2), STM32 (2), NXP (1) and Raspberry Pi (1).

How big is a typical board using the AP2171W?

The median is 80.7 × 70.7 mm, and 25% are two-layer designs.

What is the most popular open source board using the AP2171W?

By GitHub stars, Ups to esp32 by aronreid, with 63 stars.

Can I simulate one of these boards using the AP2171W before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part