13 open source boards using the C3113
Real designs built with the C3113, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
Sk162-herd mixer
mirdej
104.3 × 106.8 mm223 parts4LNo license47
RP2040/RP2350Thor's Arsenal
shannon-greenlight
70.8 × 110 mm300 parts4LGPL-3.01
STM32CCTV3 F407 REV200
aiex718
70 × 80 mm220 parts4LNo license0
Building blocks
99 × 70.7 mm162 parts2LNo license47
ESP32Full
TMANTsmith
54 × 106 mm51 parts4LNo license1
ESP32Sk612-delay
100 × 95 mm159 parts4LNo license47
Sk801-rgb
98.5 × 34.6 mm135 parts2LNo license47
AVR/ArduinoSk730-cv sequencer
101 × 107 mm130 parts2LNo license47
Sk101-inAndOut
41.9 × 98.4 mm110 parts4LNo license47
Sk123-counter
20 × 128.5 mm87 parts2LNo license47
Sk001-master input
41.9 × 82.6 mm74 parts4LNo license47
Sk800-rgb
43.3 × 109.5 mm66 parts2LNo license47
Sk005-monitor resyncer
49 × 43 mm62 parts4LNo license47
The C3113 in open source designs
The gallery holds 13 open source boards using the C3113 from 4 GitHub repositories; a typical one measures about 70 × 98.4 mm and carries around 130 components.
62% use four copper layers or more, and 8% carry an open source license.
The most starred is Sk162-herd mixer by mirdej.
Microcontrollers on boards using the C3113
What boards using the C3113 are built for
C3113: common questions
Where can I find a C3113 reference design?
Each of the 13 boards on this page is a real design using the C3113. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the C3113 use?
Most are built on ESP32 (2), AVR/Arduino (1), RP2040/RP2350 (1) and STM32 (1).
How big is a typical board using the C3113?
The median is 70 × 98.4 mm, and 38% are two-layer designs.
What is the most popular open source board using the C3113?
By GitHub stars, Sk162-herd mixer by mirdej, with 47 stars.
Can I simulate one of these boards using the C3113 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.