5 open source boards using the L293
Real designs built with the L293, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
ESP32
Ai robot hardware
robot-uprising-hq
30.5 × 62 mm22 parts2LNo license5PIC
Pi protobot
webertom6
60.8 × 90.3 mm49 parts2LMIT0MotorDriver
strah19
70 × 70 mm20 parts2LNo license0AVR/Arduino
Mood
wrightedu
53.9 × 54.2 mm11 parts2LNo license0Motor Speed Controller
SelvaUx
132.5 × 135 mm12 parts2LNo license0
How designs wire the L293
Read from the KiCad layouts of 5 open source designs, one per repository: what each pin of the L293 connects to, and the resistors, capacitors and other passives placed on it.
| Pin | Connected to | Parts on the pin |
|---|---|---|
| GNDpin 4, 5, 12, 13 | Connected to: GND 80% | — |
| VCC2pin 8 | Connected to: VCC 60% · a signal 40% | — |
| VCC1pin 16 | Connected to: 5V 80% · a signal 20% | — |
10 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Ai robot hardware by robot-uprising-hq, Motor Speed Controller by SelvaUx, MotorDriver by strah19 and Pi protobot by webertom6.
The L293 in open source designs
The gallery holds 5 open source boards using the L293 from 5 GitHub repositories; a typical one measures about 60.8 × 70 mm and carries around 20 components.
100% are two-layer designs, the rest use four layers or more, and 20% carry an open source license.
The most starred is Ai robot hardware by robot-uprising-hq.
Parts used alongside the L293
Microcontrollers on boards using the L293
What boards using the L293 are built for
L293: common questions
Where can I find a L293 reference design?
Each of the 5 boards on this page is a real design using the L293. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the L293 use?
Most are built on AVR/Arduino (1), ESP32 (1) and PIC (1).
How big is a typical board using the L293?
The median is 60.8 × 70 mm, and 100% are two-layer designs.
What is the most popular open source board using the L293?
By GitHub stars, Ai robot hardware by robot-uprising-hq, with 5 stars.
Can I simulate one of these boards using the L293 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.