9 open source boards using the MIC

Real designs built with the MIC, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

9 boardsClear filters|Most starred

How designs wire the MIC

Read from the KiCad layouts of 7 open source designs, one per repository: what each pin of the MIC connects to, and the resistors, capacitors and other passives placed on it.

  • Pin S1 is left unconnected on 4 of 4 designs.
  • Pin S2 is left unconnected on 4 of 4 designs.
  • The VDD pin is tied to GND on 2 of 3 designs.
GNDpin 2Connected to: GND 71% · a signal 29%
VDDpin 5Connected to: GND 67% · 3.3V 33%
Pin S1Connected to: Not connected 100%
Pin S2Connected to: Not connected 100%

3 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include BitDogLab 5.4 by BitDogLab, Projected by jonnor, Mic array 24 by scarbajali and BitDogLab 5.4 by BitDogLab-Escola4-0.

The MIC in open source designs

The gallery holds 9 open source boards using the MIC from 9 GitHub repositories; a typical one measures about 87.9 × 123.9 mm and carries around 56 components.

100% are two-layer designs, the rest use four layers or more, and 56% carry an open source license.

The most starred is BitDogLab 5.4 by BitDogLab.

Parts used alongside the MIC

Microcontrollers on boards using the MIC

MIC: common questions

Where can I find a MIC reference design?

Each of the 9 boards on this page is a real design using the MIC. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

How is the MIC pin S1 connected?

Pin S1 is left unconnected on 4 of 4 designs. Counted from the KiCad layouts of 7 open source designs using the MIC.

How is the MIC pin S2 connected?

Pin S2 is left unconnected on 4 of 4 designs. Counted from the KiCad layouts of 7 open source designs using the MIC.

How is the MIC VDD pin connected?

The VDD pin is tied to GND on 2 of 3 designs. Counted from the KiCad layouts of 7 open source designs using the MIC.

Which microcontrollers do boards using the MIC use?

Most are built on Raspberry Pi (5) and STM32 (1).

How big is a typical board using the MIC?

The median is 87.9 × 123.9 mm, and 100% are two-layer designs.

What is the most popular open source board using the MIC?

By GitHub stars, BitDogLab 5.4 by BitDogLab, with 204 stars.

Can I simulate one of these boards using the MIC before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part