6 open source boards using the Power
Real designs built with the Power, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
- schematic only · 88 partsGD32
Aixun t3a rev
c0d3z3r0
88 partsNo license54 PIC
OpenAC1
davischris
191.5 × 97.6 mm71 parts2LGPL-3.04STM32
ODAmain ver2.0
boiled-mackerel
100 × 50 mm79 parts2LNo license0STM32
Atmo monitor
gpgreen
60 × 66 mm21 parts2LMIT0Pdf viewer
tyano463
42.2 × 20.9 mm17 parts2LNo license0Short checker
boiled-mackerel
35 × 30 mm15 parts2LNo license0
The Power in open source designs
The gallery holds 6 open source boards using the Power from 5 GitHub repositories; a typical one measures about 60 × 50 mm and carries around 46 components.
100% are two-layer designs, the rest use four layers or more, and 33% carry an open source license.
The most starred is Aixun t3a rev by c0d3z3r0.
What boards using the Power are built for
Power: common questions
Where can I find a Power reference design?
Each of the 6 boards on this page is a real design using the Power. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the Power use?
Most are built on STM32 (2), GD32 (1) and PIC (1).
How big is a typical board using the Power?
The median is 60 × 50 mm, and 100% are two-layer designs.
What is the most popular open source board using the Power?
By GitHub stars, Aixun t3a rev by c0d3z3r0, with 54 stars.
Can I simulate one of these boards using the Power before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.