5 open source boards using the RESET
Real designs built with the RESET, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
STM32
ODAmain ver2.0
boiled-mackerel
100 × 50 mm79 parts2LNo license0AVR/Arduino
ServoBoard
jeffrey500
82.8 × 53.3 mm66 parts2LNo license0The-Gate-Opener PCB display module
maudeve-it
50 × 40 mm15 parts2LMIT0STM32
YAMADAmain ver2.0
boiled-mackerel
50 × 50 mm69 parts2LNo license0Rev a physical
ddanila
200 × 200 mm119 parts4LNo license1
The RESET in open source designs
The gallery holds 5 open source boards using the RESET from 4 GitHub repositories; a typical one measures about 82.8 × 50 mm and carries around 69 components.
80% are two-layer designs, the rest use four layers or more, and 20% carry an open source license.
The most starred is Rev a physical by ddanila.
Microcontrollers on boards using the RESET
What boards using the RESET are built for
RESET: common questions
Where can I find a RESET reference design?
Each of the 5 boards on this page is a real design using the RESET. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the RESET use?
Most are built on STM32 (2) and AVR/Arduino (1).
How big is a typical board using the RESET?
The median is 82.8 × 50 mm, and 80% are two-layer designs.
What is the most popular open source board using the RESET?
By GitHub stars, Rev a physical by ddanila, with 1 stars.
Can I simulate one of these boards using the RESET before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.